LAVAMAT MOTOR DOES NOT RUN

Pease don't type in all CAPS Anonymous, it is considered SHOUTING and is harder to read.

It is a motor circuit fault

I have a AEG Lavamat 72800 which doesnt start any cicle ...

JustAnswer https://www.justanswer.com > UK Appliance Repair
Oct 13, 2011 - Hi. Ok lets get the correct error code out. To do this turn the dial to any setting and let it light up. Then press and hold the rinse hold ...

1 answer · Top answer: Hi Ok E54 means motor relay contacts sticking or motor down to earth. The relays are ...

I keep getting a error E50 on my AEG Lavamat model ...

JustAnswer https://www.justanswer.com > UK Appliance Repair
Jul 5, 2012 - E50 is a motor circuit fault. Check the carbon brushes again, see if they've broken or stuck. Check the wiring to the motor. Let me know ...

1 answer · Top answer: Hiya, E50 is a motor circuit fault. Check the carbon brushes again, see if they'

https://www.google.com/search?q=AEG+LAVAMAT+72800+ERROR+CODE+50

..

either the pump is blocked so cant pump water out so stops program.or brushes in motor worn down(both cheap fixes)

eror203 is a lens motor gear

Try this link, I am not sure if they have it.
http://www.pumpvendor.com/Jabsco_6050-0003_parts.html

E010 is a problem with the main motor. replace motor
E002 over heating replce thermistor

check the lens motor maybe the gear of lens motor is broken

We have AEG lavamat 60210 front load washer and we get E60 code after 1 min. of washing. What is the problem with the machine?

On my AEG Lavamat 62810, when I turn on a wash cycle a motor (pump?) runs for 10–20 seconds then the machine switches off, with no error message. When this happened a few weeks agao running a drain cycle seemed to cure it; now the same thing happens on spin/drain/rinse cycles too. Any ideas?

I have the same problem with my Oko Lavamat 74639 Update. I've tried changing the vacuum sensor, but no luck.
Did you get your fixed?
Olafur

Ok, the motor windings are bad. the A.C. hum is a warning that the motor will sound when the windings are separated or shorting. its unable to hold a balanced current.the motor will actually stop soon if it isn't repaired.