I live in Little Rock Arkansas, where can I get the Euro pro shark G1490 fixed? There is a shortage where the cord attaches to the iron. The iron shuts off when the cord swivels with ironing.

I had the same problem. The repair took less than 15 min. I opened the bottom of the iron and discovered what appears to be a design flaw on the cord holder/fastener. The holder is wedged so tight that it pinched the cord wire almost in half. I removed the cord, cut it off at the pinched spot and reinstalled. I also put a small piece of rubber onto the part of the holder that is made onto the body of the iron. In addition, I rotated the fastener cap so that the smooth side of it is against the cord.

Hi,
Take the cord out, cutoff the bad part and reattach...

Here is a tip that will help you to troubleshoot your iron and figure out what is wrong with it.

Electric Iron not Heating Up or not Working Right
http://www.fixya.com/support/r5300202-electric_iron_not_heating_up_or_not

heatman101

if lights are coming on its either the wire that send power to the heating element or the element itself

pry off the rubber feet on bottom of the plate there two screw hiding under rubber feet

make sure you do a self clean as often as possible to remove debris and scale from iron

push button down on top of iron to turn on iron and adjust settings and do a self clean to remove debris and scale build up from iron

your heating coil probally went bad its alot cheaper tp just buy a new iron

circuit board has shorted out that control iron functions or power wire lead has broke off inside of iron

send me manual on iron g1490

john reilly, 5640 hwy 14 w janesville wi 53548

asap

thank you

Our G1490 quit after one year. Just won't come on. Period. I can't get it to open after removing the back screws either.