I have Speed Queen front load coin machine SWFT71, keeps showing sign E dF, I reset power switch but the sign keeps on coming please help me thanks

To diagnose the issue with the Speed Queen SC30BC washer, it's important to determine which component is causing the fuse to blow. Here are a few steps you can take to help identify the problem:

1. Unplug the washer and visually inspect the wiring and components for any signs of damage, such as frayed wires or melted components.
2. Check for any loose connections, and tighten them if necessary.
3. Use a multimeter to measure the resistance across the wiring and components. If the resistance is very low, it may indicate a short circuit.
4. Check the drain pump for any blockages or damage.
5. Inspect the control board for any signs of damage or melted components.
6. Test the door switch to make sure it is functioning properly.
7. Test the water level control valve to make sure it is not stuck open and allowing excessive water into the washer.

If you are not comfortable with electrical repairs, it's best to call a professional for assistance. Attempting to repair electrical equipment without proper training can be dangerous and potentially damaging to the machine.

Call Speed Queen Support...they are very helpful. I spoke with a guy by the name of "Tim" who was very helpful.

Ed23 code is the lower drive board

https://www.google.
com/#q=commercial+speed+queen+front+load+washer+error+code+reads+Ed+23

Could be a lose spacer check in tehe back open the screws pop it off then you will have more acces

http://www.pwslaundry.com/c-295851.4-commercial-speed-queen-swfx71n3000-front-load-washer-parts-for-repair-service.html


You want the one that says Programming...

I have not fixed any of these front loaders for a while, but the top cover should come off (usually with a key), which will give you access to the coin mechanism and timer. There you usually need a 5/16 wrench or a flat screwdriver to remove the screw at the top of the mechanism.

speed queen double front load washer spinning without stop,please give some idea,thanks alot

Did you replace the striker on the door, or the door lock mechanism?

Try adjusting the striker on door.

you can get it to run by installing coin plugs in the slide are assembly or leave the top lock panel open and push the spring arm before each load for personal use.