Bosch dishwasher S16P1B shows code E:09 before the end of a cycle. What does it mean

Is yours a Bosch machine? On Bosch the H01 usually means you have turned on the Delayed Start feature on the machine. H01 means the wash cycle won't start for one hour, H02 means it won't start for two hours.
Try this website to see how to turn it off.

http://www.fixya.com/support/t24327551-error_code_bosch_dishwasher_h02


Quoting:

Kim Moynes

It means it's been set to delay the start by 2 hours
Posted on Sep 09, 2017


What is error code bosch dishwasher h02 Bosch SHE3AR72UC Builtin Dishwasher

Error code E01 means that your Bosch dishwasher is experiencing trouble with the motor.

E:09 is a fault detected in the heating circuit. Try first tripping circuit breaker (or disconnecting power cord) for five minutes and see if this can clear the error.

If that does not work, call Bosch at the number listed on the dishwasher manual. The repair is not suitable for the home user.

About E:09 I quote the good clarificatory explanation given by

"E:09 relates to a fault in the heating circuit. This new range of bosch machines do not heat the water in the same way as the older range. There is no water pressure switch on the heater assembly as the circ pump contains the heater in one complete unit (heat-pump). The control module monitors the speed & current draw of the circ pump to ensure that there is water in the sump & it is also circulating. Your machine must be less than 2 years old, so should still be under warranty. Its not a DIY fix, it needs an engineer to sort it, as it is probably a fault with either the heat-pump or the control module."

Since I do not know your skill level I can't say if you can do this repair or not.

Bosch Dishwasher Troubleshooting ' Dr. Dishwasher

www.drdishwasher.com/troubleshooting/manufacturer/bosch/
Your Bosch dishwasher can run a test cycle which will quickly go through each ... You can find a list of Bosch dishwasher error codes and their definitions here.

Bosch Dishwasher Troubleshooting ' Dr. Dishwasher

www.drdishwasher.com/troubleshooting/manufacturer/bosch/
Your Bosch dishwasher can run a test cycle which will quickly go through each ... You can find a list of Bosch dishwasher error codes and their definitions here.

I quote same wrong from other user:

Question: Model dishwasher is Bosch Exxcell SMS50E02
It stopped before the end of a cycle with the error code E:25 and the "check water" light came on
I mopped out all the residual water out of the bottom and then ran a rinse cycle, which after several trials I got to work and then it stopped at the end again with the same error code and water in the bottom as before.

Answer:
I assume by in the bottom you mean inside the dishwasher and not in the base.As long as there is no debris in the sump area and the hoses are clear it appears you have a bad drain pump.

Hope helps.

Visit Bosch web site and get a user manual. Or tray the authorized service center

I had the same problem and just today replaced the control board module. Purchased the control module online and installed in myself. Was not that difficult. undo the screws (torx screw driver needed) unhook the connections to the board and label all. Pull the board out and open, found burned connectors. Now works like a dream.

f is fill fault to much or not enough water or water in the sump white plastic base the f code will not go away until you solve the problem when the f code shows up the drain motor will run all of the time