A new Husqvarna 435 is there a place to add chain oil to machine? I only saw where there you add two stroke oil for mix is this also used for oiling chain?

SOURCE: husqvarna chain saw oiler

My Husky 36 did this. The oil pump drive gear was stripped and had to be replace. It's located under the flywheel/sprocket so you have to pull that. I couldn't find info on how to do that so had a local shop repair it for $70! Parts are cheap, labor is not.

SOURCE: husqvarna chain saw, model 455 will not oil properly bar and chai

hi cindilou50
check the oil filter from the oil tank,the oil line ,the worm gear and the oiler under the clutch.Clean the ways where the oil goes with compresed air.(after you fill out the oil tank)Also check the oil hose.

best regards savumihai71

SOURCE: need to know oil to gas ratio mix for echo 510 evl chain saw

50:1 or of its old 100:1

SOURCE: Husqvarna 359 leaking chain oil

Remove the sprocket cover, bar, and chain. Find area where oil is discharged from case--is any part of the rubber seal damaged? Next, use compressed air to clean sawdust and dirt from oiler ports in rear of bar as well as the chain slot. Are you using motor oil instead of bar oil? Make sure there is nothing to prevent bar from making close contact with oiler port in case. Reassemble all parts and adjust chain tension.

SOURCE: just got a homelite 33cc

Yes you do! The ratio is 50:1 fuel to oil. Be sure to use a modern synthetic saw oil available at home centers, hardware stores, and saw dealers. Be sure to use fresh fuel and mix the two in it's own container. Be sure to shake the container thoroughly each time just before refueling to prevent oil starvation in the engine. Don't make up more than one gallon at a time unless sawing is your business. Hope this helps!