How to install a thermostat on a coldspot upright freezer model #106628420

When it runs all the time it usually means it is running low on freon.

searspartdirect.com you need the model # to order it

Not that this diagram is a lot of help, but I did find this on a Sears website:

http://www.searspartsdirect.com/partsdirect/part-model/Kenmore-Parts/Freezer-Parts/Model-106628420/0582/0142000?sid=PDVertical

dear sir/madam
please check the thermostat setting and make sure this thermostat device is working if it,s good and working then please check the compressor relay device and all electrical connections.
and contact to your service technician , for further maintenance.

hope answer the question
thank you
please vote!

You can get parts for your coldspot on the link below.

http://beta.searspartsdirect.com/partsdirect/part-model/Hardwick-maytag-Parts/Range-Parts/Model-2506/3052/0124002?pathTaken=

Good Luck

I would replace the thermostat because is the only thing that controls the temp. , also there's a timer and a terminator but them are only for defrosting the unit.

Clean cooling coils....throughly. Check door seals.

Unplug the unit and leave it undisturbed for 24 hours. Plug the unit back in again and see if it will come to temp.

If you heard the noise at a fairly routine rate and time it was probably the defrost timer motor. Locate it and you should be able to engage it manually. It is a plug and go part to replace. Be sure to take the old one along with the make n model # with you to the parts house!!

First make sure you have a good 9v battery installed. If it is ok then the problem will probably be in the display board or the wiring connectors between the boards. CE is communication error. If your model has the electronic tempature control instead of mechanical thermostat the problem could be in there. My bet is a bad connection at display board.