Hi normally this error is
trouble with the incline motor
Test the motor with 110vac forward and backward
see the schematic diagram, with DMM and see t
The power of the Incline Motor Assembly Part1
Let me know
[email protected]
cell+whatsApp: +50588611441
SOURCE: Assembled Bowflex Tread climber yesterday. Getting
Good day!
What is the model # of your Bowflex?
SOURCE: MY TREAD CLIMBER STARTS THEN STOPS AND FLASHES E1
This is probably a faulty speed sensor or the speed
sensor is not plugged in properly. Its also possibly a faulty motor control
board or lower board. The error codes will differ between makes and models but
could be e1.
http://www.youtube.com/watch?v=TquYcOzGIw4&feature=related
http://www.youtube.com/watch?v=9G4MZh8JO2Q
http://www.youtube.com/watch?v=M7qJrRbdfBc
http://www.youtube.com/watch?v=MIIxoPtvhy8
hthttp://www.fixya.com/support/r10724803-measure_voltage_in_transforme_fitness
http://www.youtube.com/watch?v=bF3OyQ3HwfU&feature=related
Watch this videos and tip.
You must concluded if the inclination motor is faulty or Main Motor Controller Board is faulty.
SOURCE: the display on my tc3500 bowflex tread climber stopped working
adjust the REED swithc see the diagram , clean it, and tight the connector very well.
2) Tight the ribbon cable inside, clean it, for keypads operations.
God bless you see the b. diagram attached.
You would need to contact the manufacturer on this question.
224 views
Usually answered in minutes!
×