How to hook up a phono to Sony DHC-MD555? - Sony Audio Players & Recorders

do not use the phono input. the phono input ahs a preamp on it and this will cause you to have too high a signal level going into the amp.

You'll need a phono pre amp and then you can connect to aux inputs.
http://www.google.com/search?q=phono+pre+amp&rlz=1C1CHMO_enUS514US515&aq=f&oq=phono+pre+amp&sourceid=chrome&ie=UTF-8#q=phono+pre+amp&hl=en&tbo=u&rlz=1C1CHMO_enUS514US515&source=univ&tbm=shop&sa=X&ei=Kv_2UMatJoOc9QSDr4CoAg&ved=0CGQQsxg&bav=on.2,or.r_gc.r_pw.r_qf.&bvm=bv.41018144,d.eWU&fp=a656d84bcd78ba72&biw=1360&bih=643

If you have no phono inputs on the back, you will get very little to no sound. Phono inputs have a built in preamp to amplify the signal. The only option is to go to a second hand store or ham festival to see if you can find phono amplifier, runs on a 9volt battery.

Hi, kindly get the code here : www.regionfreedvd.net/ www.dvdripper.org/dvd-region-codes-vs-ntscpal/ www.regionfreedvd.net/players.html
www.dvdreviewer.co.uk/Forums/...region_code/page1
Best Regards, Jay__frt7

My SONY Model DHC FL7 my problem is when i Start the display show "push protect power" so what is the reason for that situation so what i DO?

Are you using the phono input on the Sony? If so, you're getting too much gain, you've already got a phono pre amp in the Behringer. Try using the tape or C.D. input. That should solve it.

If the tv has scart sockets you can connect,if not you can use phono lead if there is a phono output connection on the sony.

hello it sound like the output transistor could be the problem also check any capacitors for swelling and any dry joints round the transistor
good luck

shaun

PHONO requires a phono-equipped receiver, which the STR-DE598 appears to NOT be. AUX will not work because it requires Line Level inout. Traditional old-school turntables put out a very tiny drastically-altered signal which needs preamplification to raise it and flatten it out for use by downstream circuitry. THAT is the job of the PHONO section in a preamp or receiver. You need to find a phono preamp or an older receiver to run the TT through. You could slave it to the STR through its AUX then.

You need a 3.5mm mini jack coupler lead with phono plugs on end plug one end into your headphone output on ipod and phonos into your amp lead must be stereo