I cant pull the starter cord on mt coleman ct200u

Likely the recoil start assembly is binding.

check U tube Videos, especially the first one that lasts several minutes and goes over many facets of the machine.

Try this Coleman Ct200u pull start replacement

Pull cord repair is pretty generic. There are lots of videos on YouTube if this one doesn't help.


HOW TO Generator Pull Cord Repair

no set length on any recoil repair
old one will be stretched or broken

melt cord end for ease of fitting and no fraying through holes
and finishing knots

feed one end into recoil internal through outer and inner casing
then knot
set recoil spring into correct position and tension

cord is at least three times around recoil
leave excess cord out for pull handle and later adjustment

then cut .. melt end .. feed thought pull handle

then adjust as you test recoil off the motor

then fit to motor.. pull a few times

and final adjustment of cord length at the pull handle

Coleman Powermate Generator 5000 Watts / 6250 Watts ...

? 3:27
https://www.youtube.com/watch?v=IROa5QfPqkU
Nov 8, 2012 - Uploaded by Carlos Roman
This 5000 watt generator is great for backup power at home or forpower ... Coleman Powermate Generator 5000 Watts / 6250 Watts ... This feature is not available right now. ... folding handle, 1 quart, of oil, and 25ft generator convenience cord. ... How to convert a generator recoil starter to an electric starter!

pull cord won t retract Power Generators Questions ... - Fixya

www.fixya.com > Forum > Tags > pull cord won t retract

Power Generators pull cord won t retract questions and answers. Ask your pull cordwon t ... Question about Powermate Powermate 5000W Generator. 2 Answers · I was running my coleman powermate 6250 gen power ... cord 6250 trips out ... The pullcord does not rewind onto the pulley when pulled. At first I thought it was ...

Best Portable Generator Reviews

Hi Bob:
Sounds like the engine is seized.
Try removing enough bits so you can access the flywheel and see if you can turn it. Make sure ignition is OFF.
If the flywheel does not turn it will be time for a learning experience, a trip to the maintenance shop, or a replacement.

If its on the compression stroke when you are pulling it will be hard to pull it, because you're fighting against the compression of the engine, make sure the valves are at the correct position and not fully closed when you are pulling.

you may have bent the crank shaft if it pulls hard and pulls back then remove the flywheel and check the key