My HP Color LaserJet PRO M177fw is stuck in initialization. The printer starts to do the start up procedure, i can ear the parts moving but after a while everything stops and keeps saying in the screen "Initializing". I alredy atemp to do a reset and update firmware but the problem continues. Can someone help me please?
Seems the wifi controller in the printer is fried. This worked for me.
Power on
Press Home button repeatedly while the unit is powering up.
When the menu appears hit these items quickly
1. Wireless Menu Icon (wifi icon)
2. Wireless Menu Button
3. Turn Wireless On/Off Button
4. Off Button
You have about 2.5 seconds to do this so it likely will take a few tries. When you have successfully disabled the wifi, the printer menues will work and the initializing sequence will finally complete.
You will have to hardwire the printer to an ethernet network or use some sort of wifi to ethernet adapter if you want to print over the network but the printer still works.
SOURCE: Cannot run printer...stuck on Initializing
hi,
please go through the following link
http://h10025.www1.hp.com/ewfrf/wc/document?docname=c01330821&cc=us&lc=en&dlc=en&product=390328
thanks and regards
agnel
SOURCE: HP color LaserJet 2600n stucked on Initialzing
Well we can check and see if the printer is able to run an engine test. This is how you can run this test;
If the printer is able to print this page there is a very good indication the problem revolves around the PCA formatter board.
The Firmware might be outdated and causing this problem. Worst case scenario the board might be faulty, in that case your better off buying a new machine, since the cost to replace the board will be higher than that to replace this machine.
SOURCE: No CD... iRiver h10 stuck on system initializing
Try Here:
http://iriverinc.com/support/hd/
If that doesn't work check out the forum at:
http://www.misticriver.net/forums/h-10-h-20-series/
SOURCE: Firmware updates for hp CLJ 47000dn
you can down load and software and firmware for free from HP's website.
hope this helped
please rate well
If you need further help, reach me via phone at https://www.6ya.com/expert/mark_445a24324be9eb03
SOURCE: Constant Initialization
on the main board ic3 and 2 you will see two fuses fu2 and 1 see which one is blown and replace the ic on next to it. it will work. rb..
962 views
Usually answered in minutes!
×