Sauna does not come on when I push the activation button. Instead the display shows OH.

it must have a reset button on the system ,if not you might see a small hole on the switch, take a small pointed ie,toothpick and push it in to the small hole this is the reset,it should be on the main panel.,Adrian,....

Try:

• Push either up or down arrow to make the display show "Set" temperature
• Then push "Mode" or "Light" button.
• This will toggle the filtration/heating settings between Ec, St, and Slp.
  • You will have to do the above each time to go to next Mode.
• If the above does not work, then try pushing the Jets button instead of Mode/Light button.

My sauna is having the same error, did you find a solution?

"A sauna is a small room or house designed as a place to experience dry or wet heat sessions, or an establishment with one or more of these and auxiliary facilities.
A sauna session can be a social affair in which the participants disrobe and sit or recline in temperatures typically between 70 degrees C (158 degrees F) and 100 degrees C (212 degrees F). This induces relaxation and promotes sweating.
Saunas can be divided into two basic styles: conventional saunas that warm the air or infrared saunas that warm objects. Infrared saunas may use various materials in their heating area such as charcoal, active carbon fibers, and other materials."

What is a code 4 mean on a cedrus sauna

Press the Alarm button. The weekday alarm symbol will appear. Then press and hold the Alarm button for 2 seconds to enter the set mode (the hour will blink). Use the up/down buttons to choose the hour for the alarm (note the A.M./P.M. if in 12 hour mode). Press Alarm again and the minute will blink. Again use the up/down arrows to set the desired time. Press Alarm once more to exit the set mode.

To activate or deactivate the alarm, press the Alarm button until the weekday alarm icon appears. Then use the up/down arrows to activate or deactivate the alarm. When the alarm is set and active, the time will show. If the alarm has been deactivated, then dashes will appear instead of the time.

The single alarm is set and checked similarly.

I hope this helps.

Cindy Wells
(I suspect that the weekday alarm icon continues to display when the alarm is active.)

Hi my name is Mike I am with Mr. Steam Product Support. PRR is a code that shows up on our Steam Bath controls it was not used on our Sauna's. The PRR means there is a problem with the temp sensor on the control.please call me at 800-767-8326

Hello,

I just had this issue with my camera (my 15 year old son solved it for me ;-) ).

The viewfinder was active in "record" mode and the LCD was "active" because you could see a little back light but no image. The "playback" mode would let me review pictures in the LCD though so I know it is capable of showing information.

If you push the display key/button a couple of times you can see the picture move from the viewfinder to the LCD and have just a picture and or a picture and information.

So try setting the camera to "record" mode (lens comes out) and then push the "display button" which is on the back of the camera just to the right of the LCD on the lower right side several times and see if the LCD starts to work.

It could be that somehow the display button was pushed by mistake.

Bill