IMB Wheelwriter 1000 By Lexmark
SOURCE: lexmark wheelwriter 1000
Check the keyboard connections. Open the top cover and look just below from the top. You will see two ribbon cables. Make sure they are fully inserted. Are any of the keyboard lights flashing?
I’m happy to help further over the phone at https://www.6ya.com/expert/jayw_0e86fb055a7b73de
SOURCE: LEXMARK WHEELWRITER 1000
Sounds like a keyboard, if you send it to us we can repair it for about 125.00.
[email protected]
hope we can help you
DickyO
SOURCE: IBM Wheelwriter 1000 by Lexmark
The beeping problem is that spell check is on try code 1.
Pedro;
I'm not sure what your question is but it sounds like you are in caps. Try code C.
DickyO
SOURCE: character spacing
There is no pitch switch for this typewriter. The only way that you can change the pitch is by changing the printwheel that has the pitch you want. So if you want to type in 10 pitch you have to install a 10 pitch printwheel the same for 12 and 15.
SOURCE: The correction tape is not working properly. Wheelwriter 1000
If everything was working befor the ribbon & L/O change Either the L/o is not properly attached to the ribbon or the ribbon and or L/O are old. Make some corrections then remove and look at the L/o, if the letters are near the center of the L/O the problem is the ribbon or L/o is old, if the print is on the top of the tape it is not properly attached to the ribbon or not coming out or the cassette properly.
If you have a fresh set or another T/W that works swap the ribbons and look at how they are attached.
For a picture ngo to lexmark.com and click your way to publications you will find a downloadable manual there.
DickyO
Testimonial: "Thank you, very helpful."
35 views
Usually answered in minutes!
×