Pramac S7500 turns over but will not start and stay running

If the plug of your Pramac PX5000 generator gets caught in an AC socket, follow these steps:

1. Turn off the electricity to the socket.

2. Wear insulated gloves for safety.

3. Gently wiggle the plug while pulling it out.

4. Apply a bit of lubricant if needed.

5. Use insulated pliers to grip and pull the plug.

6. If you cannot take it away, get help from an expert electrician to keep it away from harm or injury.

If your Pramac 12k battery charger is displaying a failure alarm, there could be a few possible causes:

1. Check the voltage level of the battery: Make sure that the battery is at the correct voltage level and that it is properly connected to the charger.
2. Check the charger connections: Make sure that the charger is properly connected to the power source and that the connections are not loose or damaged.
3. Check the charger's fuse: Make sure that the charger's fuse is not blown.
4. Check the charger's cooling system: Make sure that the charger's cooling system is working properly and that it is not blocked or damaged.
5. Check the charger's electronic board: Make sure that the charger's electronic board is not damaged or malfunctioning.

Disconnect all loads before turning on breaker. Add one load at a time. Do not exceed generator capacity.

Comment below for further assistance.

website reliablestore it is very good.. I used it to repair my shredder it had some spark issue which wasn't easily fixed. you can go there and try

Crack open an injector line.

buy new

The first thing I would look for would be internal fuses blown. This sounds like a 460 volt 12,000 watt industrial generator and you probably should call the installing contractor for service. My 15,000 watt generator is over 30 years old and has less than 700 hours on it and those are mostly test-run hours.

Try a shot of starting fluid. If it does not start with that it may have a fuel supply problem.

clean out the carb

It may have a seperate starter button