Question about Craftsman 42 in. Deck 19.5hp Lawn Tractor

1 Answer

Were is dipstick or sight glass to check hydraulic fluid in a 2014 4025 Mahindra tractor

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Craftsman Master
  • 3,462 Answers

Ask a "Mahindra" dealer. Look one up on your computer.

Posted on Jan 19, 2018

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 463 Answers

SOURCE: IJohn Deere whinning noise

Is the device that lowers or raises the loader a hydraulic piston type device, or more of a hydrostatic type device? Whining noises are not uncommon with hydrostatic devices...

Posted on Mar 26, 2009

Anonymous

  • 6 Answers

SOURCE: where do fill up hydraulic fluid on a 1490 case

backend by the linkage someware, sory but dont know what oil to use

Posted on May 19, 2010

Philip McCarty

  • 1 Answer

SOURCE: where do you check hydraulic fluids on a 460 international tractor

I own one. Most have a plug in the top of the trans/hydro case to the left and rear of the gear shift leaver. It takes a 3/4" drive to open it. I use an extention and brake bar or ratchet. The fluid should just all most reach the opening. the books state it should hold 8 to 10 gal. I have found my 460 Utility holds almost 20 gals.

Posted on Jan 07, 2012

newmansoil

Rod Newman

  • 2 Answers

SOURCE: We have an 1961 International

hydraulic fill is on the left side below the gas tank in front of the hydraulic valves square plug oil level 1/2 inch below plug

Posted on Sep 26, 2012

Ted Maxwell

  • 3519 Answers

SOURCE: Mahindra 2615 2007 tractor is spraying hydraulic fluid by two of the brass couplers underneath the lever. I wondered for troubleshooting should I just repair/replace tractor components .

Hi Benjamin:
I have a fleet of equipment that have hydraulic components, and one of the most regular maintenance tasks is replacing failed or worn components.
Running hydraulic equipment with leaks present is a real safety hazard as the part could fail resulting in hot high pressure fluid being sprayed unrestrained.
Please, do not run the machine until you replace the defective part.
Hopefully there will be a local hydraulic hose shop that can assist you.
Cheers.

Posted on Jan 27, 2016

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have. Mahindra 7060 and an alarm is going off about 5 minutes of starting. There are no indicator lights going off on the dash. What could this be


I had the exact same problem with my 7060. It is caused by a switch (relay) that monitors the hydraulic fluid. The switch is under the floorboard on the driver's right side. The tractor will act the same if you have low hydraulic fluid.

Sep 04, 2017 | Mahindra Cars & Trucks

1 Answer

Were is dipstick or sight glass to check hydraulic fluid in a 2014 4025 Mahindra


First point, this question was listed in the motorcycle section and its a tractor, Du, one has four wheels the other two. Pop the hood and look on one side or the other of the engine, you are looking for what looks like a jam jar full of oil. That SHOULD be your hydraulic fluid, tis on most tractors, although sometimes they are not glass but steel.
Hope this is of some help.

Aug 19, 2017 | Mahindra Motorcycles

1 Answer

Dipstick or sight gauge location on Kubota Tractor/Backhoe TL421 needed. Changing fluids and cannot locate the level gauge.


motor oil stick is if sitting in seat facing forward , its on right side , just by your right ankle , in a little offset in the block ( loop handle sticks out by right ankle) hydraulic oil level is a sight gauge (glass) they do get covered up with grime over time and need to be wiped off to see them !!! me I look down fill tube with light and measure three inches off tank top (heat expansion room)

Oct 12, 2016 | Kubota Garden

1 Answer

Mahindra 2615 2007 tractor is spraying hydraulic fluid by two of the brass couplers underneath the lever. I wondered for troubleshooting should I just repair/replace tractor components .


Hi Benjamin:
I have a fleet of equipment that have hydraulic components, and one of the most regular maintenance tasks is replacing failed or worn components.
Running hydraulic equipment with leaks present is a real safety hazard as the part could fail resulting in hot high pressure fluid being sprayed unrestrained.
Please, do not run the machine until you replace the defective part.
Hopefully there will be a local hydraulic hose shop that can assist you.
Cheers.

Jan 26, 2016 | Mahindra Cars & Trucks

2 Answers

Don't know how to read the hydraulic dipstick for a 1944 ford 2n tractor


Ford Tractor Hydraulic System - My Ford Tractors

www.myfordtractors.com/hydraulics.shtml
All N-Series Tractors - Ford-Ferguson 9N, 2N, and Ford 8N ... 6 - How long has it been since you changed the hydraulic fluid? ... If that didn't do it, read on. ... then remove the bottom bolt from the inspection plate that has the hydraulic dip-stick.

Yesterday's Tractors - Fifty Tips for Ford 9N, 2N and 8N ...

www.yesterdaystractors.com/articles/artint268.htm
I'd like to say that the reason I have an 8N Ford tractor is because that's the tractor ... The N tractors have a common sump for the rear end, hydraulic pump andtransmission. ... (Read the label.) .... Take the inspection plate with the dipstick off.

Ford 8N, 9N, 2N, NAA Tractors Information - SSB Tractor ...

www.ssbtractor.com/wwwboard/messages15/
Helpful information and resources on Ford 8N, 9N, 2N, NAA tractors from SSB Tractor, a leading provider of tractor parts, manuals, implements ... 1944 ford 2n: What type of oil to use? and whats the oil pressure should be? ...... N Series Trans/Hydro Fluid - Interesting To Read ... Ford NAA/Jubilee Hydraulic dipstick location?

Jan 01, 2016 | Ford Cars & Trucks

2 Answers

How to check the hydrolick fluid on a 1972 ford 5000 it has no dipstick I just got this tractor


Ford Tractors Information - SSB Tractor Forum

www.ssbtractor.com/wwwboard/messages4/
Helpful information and resources on Ford tractors from SSB Tractor, a leading provider of tractor ... tractor pumps oil but won't pump hydraulic fluid ..... 1972 Ford LGT165 lawn and garden tractor hydraulics ..... Ford 5000 transmission oil level

Aug 17, 2015 | Ford Cars & Trucks

1 Answer

Where do I check the hydraulic fluid on a mahindra 3016 hst


I'm not terribly too sure about the Mahindra, but I have recently had to check my hydraulic fluid and I consulted with the manual. Do you have a manual for your vehicle? If you don't, then I would get a repair kit which should have some instructions that could help you out with your situation. https://www.hydrapakseals.com/storefrontCommerce/hydraulicRepair.do

Feb 24, 2015 | Mahindra Cars & Trucks

1 Answer

Where's dip stock for hydroloc fluid on a Kubota L3400 4x4 tractor


As a rule the Kubota L2800/L3400 do not have a dip stick for the hydraulic fluid. To check the fluid level, find the small round site glass that is on the transmission, left side, just in front of the clutch pedal. This sight glass has a level line on it. If the level is low the fluid might not show in the sight glass. If the level is below the line add fluid. The fill port for the Hydraulic fluid is on the back of the tractor just below the level of the seat.

Oct 31, 2014 | Garden

1 Answer

Where on the Dixon ztr 5421 do you check the hydraulic fluid


there should be a sight glass or a dip stick in the
hydraulic tank.

Jun 14, 2009 | Garden

Not finding what you are looking for?
Craftsman 42 in. Deck 19.5hp Lawn Tractor Logo

Related Topics:

843 people viewed this question

Ask a Question

Usually answered in minutes!

Top Craftsman Garden Experts

john h

Level 3 Expert

22486 Answers

Sheldon Dedek

Level 3 Expert

909 Answers

rjivaro

Level 2 Expert

158 Answers

Are you a Craftsman Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...