How to Input code 93 bar code into the Hobart quantum scale?

Located on the left side of the scale, to the right of the
Modnet port, is a small button. This is the Reset Button. If
the scale stops responding, use the Reset Button to reset the
scale back to the Start a Run Screen.
To reset the scale, PRESS and hold the Reset Button for 2 to
3 seconds.

Try an other code.
http://remotesearch.blogspot.com/
http://electrohelponline.blogspot.com/

You can go to Hobart.com:

http://www.hobartservice.com/main/default.aspx

and create a new user and download a manual.

The is something called a duty cycle and if you exceed that rating then you have to wait for it to cool off to use it again.

There is no ink. It has a thermal printhead.

sounds like it is setup to print a secondary label. go into supervisor mode 10 and check to make sure the secondary label setting is at 0

you need to add a ean13 label type to your scale. this is something only a service tech. or hobart rep can do.