Reset photoconductor count on lexmark x264dn - Lexmark Office Equipment & Supplies

1.open the front cover. Leave the printer powered on. 2. With the front cover open, press and hold the stop/cancel (X) button. 3. Eventually all of the lights will begin flashing, indicating that the photoconductor page count has reset. When you see this light sequence, let go of the X button.
4. Close the front cover.
NOTE: If you wish to confirm that the photoconductor page count has reset, print a menu settings page.

That's mean you need to change photoconductor kit. Usually with HP printers that part is inside the toner so you change it every time you change the toner but not on some Lexmark printers.

Nabeel Jerjis

To reset the PC page count, while the printer is on, open front cover then press the cancel button.
NOTE: The photoconductor page count should be reset only when a brand-new photoconductor kit is installed. Resetting the page count without replacing the photoconductor kit could cause the photoconductor to operate beyond its intended life and thus create print quality issues.

Here's an article on How to Reset the Photoconductor Page Count on a Lexmark E340 or E342. Click on this link http://bit.ly/b1Qil7. Thank you for choosing Lexmark.
NOTE: Resetting photoconductor page count should be done only when a brand new photoconductor kit is installed. Doing so without replacing pc kit could cause print quality issues.

NOTE: Resetting the photoconductor counter/page counter should only be done whenever you replace the photoconductor unit.
Here's an article in the Lexmark website on how to reset the photoconductor page count. Just click on this link: http://bit.ly/9WAvUK. Hope this helps.

Whenever you replace the photoconductor unit, remember to reset the PC counter. With the printer powered on, open the front door/cover. Press and hold the cancel button until all the lights flash. This indicates that the photoconductor page count has been reset. Hope this helps. Thank you for choosing Lexmark.

Here's the link to the Lexmark website for instructions on how to install the photoconductor and resetting its page count on a Lexmark X340n. http://bit.ly/c66dvv. If 84 Replace Photoconducter message is still on the display after performing the steps, refer to this link on how to reset the photoconductor page count. http://bit.ly/bm3XBm. If all else fails, I suggest you contact Lexmark Technical Support for further assistance.

Here's a link to the Lexmark website for the instructions on how to reset the photoconductor page count through the printer's Configuration Menu. http://bit.ly/bEa8u9. Follow the instructions carefully. Hope this helps. If you need more assistance, leave a comment and I'll get back to it. Thanks.

According to Lexmark E450DN service manual;
1. Turn off the printer.
2. Press and hold Checkmark and Right Arrow buttons.
3. Turn on the printer.
4. Release the buttons when 'Performing Self Test' displays.
The message CONFIG MENU displays on top line of operator panel.
5. Scroll down and select 'Reset PC Cnt.'

Here are the steps to reset the page count on a Lexmark E234, as described here:

1. Power the printer on and get it to the Ready state.
2. With the printer on and in the Ready state, open the front cover.
3. Press and hold the Cancel button until all of the lights begin flashing up and down.
4. Release the Cancel button and close the door. The photoconductor count should now be reset.

Hope that helps!
-MetaB