Water remains at the bottom of the dishwasher

check filter trays at bottom are clean also bendy straw jammed in empty pump impeller

Please check the fill valve

this will sound silly but the amount of times this has been the cause will justify the question, if the drain hose is conected to a spout off the sink trap, has the plug at the base of the spout been removed to allow water to drain?

Otherwise >

disconect the power then tilt the dishwasher about 45 degrees to the front then back, hold it in each position for about 10 seconds, water will come out so be prepared for that. back to level and try it again,

this may seem like a stupid question but is there definately water a supply to the dishwasher, has it worked where it is before?

Your drain might be plugged. Check the bottom drain. If the water has no where to go, it will fill the bottom up. There might be a cap since it is new. It has to have a place to drain.

Hi,
Here is a tip that I wrote that will help you with your dishwasher not drainingproblem...

Dishwasher Problems - Water will not drain out

heatman101

heres a screen on the inlet to the water solinoid that plugs up with calcium alot of the time. shut off the water and take the bottom panel off the unit and you will see where the solinoid is. take off the water and then take the solinoid out and apart to clean. reassemble and you will be good to go.

• hot water valve selinoid and cold water selinoid valve are magnetily operated valves located in the lower part of the dishwasher that need electricity-----
• wire loose?
• kinked supply hoses and
• my favorite is the valve at the kitchen sink angle stop is lying to you, indicates open but is really still shut (broken valve stem) or it has corroded shut .

I have now managed to remove the side panel. The removal of the top was needed before the side could be dealt with. The top remaval is shown in the instructions for the unit. Two ligs at the rear need to be pressed in using a screw driver. The top then will slide to the rear and lifts off. This procedure is for the Siemens model SE25T850GB08 however I suspect that the model this case is attached to would be the same. I've now resolved my issue in this case. I still however have not been able to resolve the water draining problem.

Following a cycle, a small pool of clean water inside the tub is typical. Excessive water means the pump isn't pumping water out properly, the drain hose isn't carrying it to the drain pipe, or the house's drain lines are backed up. If dirty water spews from the air gap, the drain line is kinked or clogged. Note: If you've recently installed a garbage disposer, be sure the knockout plug for the dishwasher was removed when the connection was made (see your disposer instructions).