Error Message and Tub not spinning

There are pressure switches (weighs the tub) connect to the tub... towels and sheets hold more water and therefor weigh more.. try washing less pieces and see if that helps..

This is another example of our government knowing whats best for us!! I have to wash two or three more loads.. and THEN rinse and spin each to get them clean.. I use A LOT more water this way...
oh well...

Follow the link for help diagnosing this error code http://www.lg.com/us/support/product-help/CT10000010-1337714738535-oe

OE is normally down to blocked drain pipes, mcalpine (connection under the sink) or a blocked front filter. empty the machine and unscrew the filter behind the flap at the bottom right hand side, check for any obstructions, icoins, hair grips etc are normally blocking here

if the machine fails to spin and makes noise there are thee things to check .if it fails to drain the water check if something is stuck on the drain pump no 2 turn the drum with your hand and check if the drum is moving freely if not something is stuck between the drum and the housing if the bearings are faulty the machine spins but makes alot of noise towards the end of the cycle i hope this will help you.

Might be "tE" error code. Thermistor error. A $6 parts and pretty common and causes the symptoms you described.

Hi,
Here is a tip that I wrote that gives more detail about how to fix the OE codeon LG washers....

LG Washing Machine OE Error Code
heatman101

you can go appliancerepairplanet.vstore.ca and you can get help there.

It is a long drain error and occurs when the washer is not fully drained after 10 minutes of draining. Remove the cabinet cover and check the following:

1. Drain Pump Connector The connector may be disconnected or disassembled. Reassemble or repair if necessary.
2. Drain pump coil
   Check pump coil resistance between the terminals using an ohmmeter. Resistance should be between 10-20 ohms. If the resistance is too high or too low, replace the drain pump.
3. Voltage Check the voltage between the connector in step 1 during spin. The voltage should be 120Vac, else replace the main board assembly

Main board replacement:

1. Disconnect the power connector and sensor switch assembly.
2. Remove the main board protective cover.
3. Disconnect the connectors.
4. Remove the screw on the back of the main board.
   
5. Slide the main board to the right then pull it up.
6. Replace the main board in reverse order above.
   

make sure your outlet hose is not constricted or blocked in any way.

will it spin after it washes if it does not then your belt might be broke