That information is found in your form guide. It's generally located in a waterproof bag affixed to the inside wall of the washer. You need to open the the top to gain access to it. Locate two spring loaded clips approx. 6 inches in on either side between the top and bottom of the machine with a 2 inch putty knife/scraper. Once located, take the putty knife out and push in and up on the clip. I use a wood wedge to hold it up until I release the clip from the other side. The back of the machine top has a hinge so don't put it back too far. The bag should be on the left side. Just push the rubber seal on the top back a bit. If the bag is empty due to a previous repair, it maybe located under the back panel. Remember to always unplug the machine before you attempt any repairs.
SOURCE: Maytag Washing Machine Model LAT9706AAE Won't
Check at the back of it,the rubber belt may have become loose or sometimes slips off it course and may need re-fixing....
SOURCE: Our Maytag Washing Machine Model number MFW9700SQ1 stinks!
This is a common problem, you can run a few cups of vinager or bleach in a empty load set to hot wash and this will help. To keep it from coming back when your done doing wash wipe the door gasket down with a rag dampened with bleach and never shut the door all the way. Good Luck
SOURCE: hotpoint wm 53 first edition 1200 wiring diagram
Please reply with the model # if you still need the diagram.
Thanks for using FixYa - a 4 THUMBS rating is appreciated for helping with your FREE question
SOURCE: Wiring diagram for GE Washing machine WWA8852 RBMWW
In the console of your unit there is a service manual. The wiring diagram is inside.
Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question
145 views
Usually answered in minutes!
×