How to add Oxiclean Powder to a Kenmore Elite Front Load washer cycle?

Either the cylenoid to let the water in is bad.
Or the hose from the dispenser to the drum is clogged.
Most common with powder detergents.
Some really hot water poured into the dispenser may
solve the problem.

Inside the dispenser drawer, at the bottom there is a tab that you can push down to remove the dispenser drawer. Remove the drawer and check if the dispenser holes are clogged, this is a common cause.

IF the instructions advise against using bleach in that machine then it is probably because the bleach will affect certain parts / rubbers of the machine and will lead to costly repairs if used.. Try a bleach free soil remover like nappy-san or vanish pink in conjunction with a liquid detergent rather than a powder detergent

liquid is best as powder is mostly made of a "clay base" in its detergents??? yes i did say clay!

Mix one ounce OxiClean powder with your powdered detergent in the detergent dispenser of your front loading washing machine.

OR

Dump one ounce OxiClean powder into the washing machine before you add clothes.

I personally suggest you do not use any powder only liquid detergent it lleans better and does not foul your machine it also will clean your empty machine as well Tide Cheer all are good liquid detergents

are you using a gel soap if not that may be your problem powder soaps cannot be used in front load machines it damagege the bearings in the back of the tub

not effectively. run the machine for a long cycle to clean any excess detergent out. the add normally through the dispenser

If you have hard water then you might want to get a water softner.And get cascade powder soap,tablespoon to a teaspoon of powder soap is all you need for a whole cycle.

dust in washing powder do,nt worry