How do I replace a broken negator spring on a paslode angled finish nailer IM250A

Try this link for an exploded drawing.
https://www.toolpartsdirect.com/paslode-im250a-impulse-angled-finish-nailer.html

The battery may be the culprit but more common is the fan motor. When the fan motor fails it will alternate red/green. The part is pretty expensive and is fairly involved to replace if you are not familiar with the tool.
Paslode nbsp900600 nbspImpulse Cordless 16 Gauge Angled Finish Nailer...
You need to remove the head cap, unplug the spark and fan wires, twist the fan assembly a few degrees to the left and it will lift straight out of the tool. Carefully remove the fan blade by loosening the tiny torx screw located on the side of the fan shaft being careful not to bend the fins.
Release the retainer on the top of the motor holding it in, unplug the motor wires and then slide it out.
Inside the motor housing is a plastic bushing that needs to be removed and replaced (part will come with the new motor).
Reverse directions to reassemble
Let me know if you have any other questions

Sounds like You need feeder spring. Is driver blade going all the way back up?

-Jeff

The Paslode gas powered tools need to be thoroughly disassembled, cleaned, and lubed periodically. If you are running the correct gauge nails (16 gauge, straight finish nails for the IM250 and angled for the IM250A) and the tool appears to be working correctly then this is probably what it needs. I do quite a few of them here at my shop and it is the most common problem.

You have a stuck head switch - it is part of a circuit assembly (#89), it may be the actuator (#66) causing it.
https://www.toolpartsdirect.com/paslode-90060-cordless-16-gauge-angled-finish-nailer.html

Hi,

Here is a tip that I wrote about the Paslode nailers and the problems that can come up with them.

I also have a link to the Paslode manuals which contain Paslode cleaning and troubleshooting guides.

If you need parts for your Paslode, there also is a link for a site that sells the Paslode nailer parts.

Paslode Cordless Nailer Problems

heatman101

=-=-

Hi,

Here is a tip that I wrote about the Paslode nailers and the problems that can come up with them.

I also have a link to the Paslode manuals which contain Paslode cleaning and troubleshooting guides.

If you need parts for your Paslode, there also is a link for a site that sells the Paslode nailer parts.

Paslode Cordless Nailer Problems

heatman101

';';][

Hi,

Here is a tip that I wrote about the Paslode nailers and the problems that can come up with them.

I also have a link to the Paslode manuals which contain Paslode cleaning and troubleshooting guides.

If you need parts for your Paslode, there also is a link for a site that sells the Paslode nailer parts.

Paslode Cordless Nailer Problems

heatman101

[]\][\

what is the exact model number on the framing nailer you have to pry the push nut off the shaft and on the finish nailer you remove the screw and then the handle. let me know and I will try and help

go to Paslode.com and you can download a manual that shows the spring. It sits in a recess under the follower that pushes the nails