My binks model 18 spray gun sprays inconsintaly on off on off ect.

http://www.bedfordprecision.com/Html_Refs/BedfordQuickRef_Binks_Model_18_Spray_Gun.html


Contact parts vendor to requestion information.

That is a great old spray gun. I used to spray auto enamel at about 35psi when I was painting cars.

67PD PE Used for Zinc rich and other abrasive coatings, the 36sd is a general nozzle that is used for most applications, if you need assistance,, heres their number Technical Support Tel. 888-992-4657 Fax. 888-246-5732 or you can check their PDF located here . http://www.southernfluidsystems.com/BICONV.pdf

spray gun is cloged (clean it!) also check gaskets in gun and vent hole in cup lid ( could be cloged)

I looked up same gun. I think I googled "binks model 2001 spray gun" and I got a pdf with all info and diagrams. On the available websites, I looked for the one that looked like official Binks site.
The PDF # I got is 77-2316R-14.pdf. It shows that #7 o ring

contact jason terrell at 270 389 0200 after 3pm

This model comes in either suction feed or pressure feed. For example a 6211-4307-9 is a suction model. There are different air caps and needles depending on feed style. I assume your'e using either a 82-545 or a 82-555 suction cup attached to the gun. Make sure the tubing is tight, and that the vent hole in top of the cup isn't clogged. See Binks.com for detailed tip combinations.

Here you can find a manual: http://www.tpub.com/content/automotiveaccessories/TM-9-4940-507-14-P/TM-9-4940-507-14-P0006.htm

Michael
[email protected] ' www.bsc-teknik.com

You can find spares for Binks 630 here: http://sprayfinishingstore.com/products/spray_gun/classics-gun/binks-630-gravity-spray-gun/

Michael
www.sprayfinishingstore.com ' [email protected]