Beamer cannot be switched on

ist der beamer nog innerhalb garantie, dan bitte zuruck zur lieferanten, am sonsten kan mann versuchen die kappen weg zu holen und die ganze sache von innen aus mal richtig zu sauberen, staub kann die sensoren storen, weicher pinsel und staubsauger konnen helfen.

viel gluck

one of the polarizer filters is burned up here is a similar replacement.
http://www.youtube.com/watch?v=A_wgbnArcu8&feature=share

plug the projector end of the cable into a monitor and check that the video is OK.
then reconnect to beamer
make sure the rgb socket on beamer is configured for pc and not component video input

First try shutting down you're system. Than turn the PS off at the rocker switch (Back of PS). Ground you're self by touching the the PS. Remove you're memory and re-seat it. Than boot the system.
Check the standby LED. See if it lights green.
Pull the cmos battery and check its voltage. Anything under 2.4 volts replace the battery. Normally the MB LED displays green. (Standby power).
This means the MB is maintaining / charging the cmos battery. If the battery can no longer maintain charge this will cause the MB LED to turn Red. Built into the mother board is a small switch. When the system is shut down the MB maintains power to the cmos. If the standby switch fails to function correctly the LED will turn Red. Lets hope the problem is the cmos battery. The internal switch can not be repaired.

Cheers'
Mike

Check all the fans if its working or avoid anything that cover the exhaust fan, or the temperature of your room.

I have the same problem. It seems we have to reset the counter. This reset must be done via the beamer itself and not via remote control, since lamp is not working...

Try to get an scan with an good antivirus or malware. If this fail... Only reinstalling OS, my friend... Succes!

if it's blinking green, nothing is wrong. it's just cooling. if it's blinking red and the lamp is off, the lamp door is open.

Hi fene4

You will have to replace the lamp and reset the lamp timer.

Daniella,

Do you have a CE version of the BM-TV, in UK the TV system is PAL if you bought your Beamer in U.S. chances are you have a NTSC version. As far as "broadband", are you refering to a DSL service or VOIP? Please email [email protected] for further assistance.


Support