At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The machine does not fill with water or 'H20' flashes in the display.
The water inlet hose is kinked. • The water inlet hose is not connected to the water supply. • The water pressure is too low. • The water tap has not been turned on to allow water to flow into the machine. • There is no water supply to the house. • The inlet valve filter is blocked. • The START/PAUSE button has not been pressed.
Faulty pressure switch machine thinks there is no water in the machine.
The washing machine fails to load water (The wording H20 is
displayed).
• The water inlet hose is not connected to the tap.
• The hose is bent.
• The water tap is not turned on.
• There is a water shortage.
• The water pressure is insufficient.
• The START/RESET button has not been pressed.
the pressure switch is jammed on empty. this could be either a faulty pressure switch, blocked pressure hose (pull off small hose and blow down to clear any debris) or a blocked sump hose ( big black hose at the bottom of appliance)
H20 is indicating a problem with the incoming water supply to washer.
Check the inlet hose/s for kinks or other restriction, ensure that you have a good pressure to the washer, make sure tap/s are fully turned on.
If all o/k,then could be a problem with the inlet valve/s
Please rate my solution.
Thankyou.
Hi.
Fault code H20 is indicating that the washer is not filling correctly, check tap/s hoses, and inlet valves for water supply.
Please rate my solution.
Thanks.
This is a pressure switch error.
It still thinks the machine is empty because the switch sees no pressure (simple dip tube).
But this may be as simple as a vent hose come off.
To check,
First isolate supply, then remove screws at top rear of the machine.
Slide the lid rearwards, and remove.
The small hoses should go to the drawer area, and the pressure switch will sit at the end of one of them.
If there are any rips or damage to a hose it need replacing.
Check all hoses are where they should be.
If this doesn't work, please ask here again so I can troubleshoot further.
Thanks for using Fixya!
×