I have to disconnect and reconnect my TEW-432BRP router

Hi there,
Router does not require driver to be used, all you have to do is to install the hardware and configure it.

1. You have to know your hardware version, so you can download your materials.
There are 5 version of your TEW-432BRP.



2. Click the link below, If you already know the version.

(Main).
(TEW-432BRP D1.2R/D1.3R)
(TEW-432BRP D1.OR/D1.1R)
(TEW-432BRP C1.xR)
(TEW-432BRP Bx.x)
(TEW-432BRP A1)

3. Download User Guide and Easy Go CD Files.
4. User Guide will help you to configure your router from start to end.

If problem persist just post and give a brief explanation on the problem.

Hopefully this helps
Thank you for posting.

Here is the PDF file that shows how to reset the router if the password is forgotten.

http://downloads.trendnet.com/TEW-432BRP/FAQ/FAQ_TEW-432BRP.pdf

you can connect your Ethernet cable from tew-432brp to MT800.

if serial ethernet cable not work you can check with cross cable of ehetrnet also.

if you live in a heavily populated area you might be experiencing interference try switching the wireless channel on the routers config page. if there's a choice for auto-channel try that.

It is because the Power adapter is not connected properly. If this happens again. Disconnect the power adapter cable from the router and from the power socket. Then connect it back again. The router will come on. It could also be because of power surge which might have stopped the system for a while

Hi,
Try with http://192.168.1.1 or http://192.168.0.1
I hope that this has been very helpful for you

Sounds like you need to configure the PC's USB wireless adaptor. The settings must be the same as the router. If you use a WEP password on the other connections then you need to have the same password on the USB wireless adaptor. Good Luck.

There is a reset button on the back of the router. Push in with a paper clip, till the lights flash. This will reset it to the factory defaults.

Then shutdown your PC. Unplug the power from the router and the cable modem.
Wait 30 sec. then plug in the power to the cable modem, wait 30 sec. then plug the power to the router. Wait till you have "Internet" light then restart your PC. The PC should pick up an IP address and you should be able to get on-line.

Here is the user guide:
http://downloads.trendnet.com/tew-432brp/manual/ug_tew-432brp.pdf

Click on this link or copy and paste the complete link into your browser.
If I could be of further assistance, let me know. If this helps or solves the issue, please rate it.


I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309

lan wires are the same. lan wires used to connect your computer to your modem can also be used to connect your Wa1003A adsl router and TEW 432 brp.

you just got some things mixed up.

1. you should set your Wa1003A adsl router to bridge mode. At this point, it will just be "pass through" device and will not be the one who will ask for IP adds from your ISP.

2. configure your TEW 432 brp with your pppoe username and password. Your TEW 432 brp will now ask the network for the IP address to that it can connect to your ISP.

3. leave your lan wires the same.

what are the setting on the router and or pc and modem? Do you have any firewall or portforwarding turned on? Are you using DHCP?
Need more info...