What does the charger for a Jet 3 ultra electric chair look like

Question edited for clarity.

You have a dead short somewhere. You need some electrical knowledge and a digital multimeter for testing. Take all the covers off. Look for wiring that has rubbed through and touching or melted. Disconnect one of the motors and replace the fuse. If it still blows, reconnect that one and disconnect the other motor. If one motor doesn't blow and the other does, you know you have a faulty motor. If neither stop the issue, then you move up to the controller and look up there. With a meter you can check for shorts within the motors, as well as grounds.

Or just take it to a Service Centre and have it repaired and serviced properly.

Basic troubleshooting

INFINFB2045 Jet 3 Ultra Troubleshooting

Pride Mobility https://www.pridemobility.com > pdf > infinfb2... PDF troubleshooting instructions for the Jet 3 Ultra Power Chair. This information is to be ... A blown charger fuse can cause the charger inhibit to activate.

• 
  

  JET 3 ULTRA

  https://www.pridemobility.com > pdf > us_jazzy
  PDF
  Jet 3 Ultra www.pridemobility.com. 3 ... If the circuit trips, allow your power chair to "rest" for approximately one minute. ... thermal fuse on each lead.

Pride Mobility Jet 3 Ultra Troubleshooting This will help.

Wall outlet bad? Charger not turned on/plugged in right? Something disconnected? Bad battery connection? Blown fuse in chair or charger? Bad battery or batteries?

rectifier on charger

The chair should have a meter on the rear panel where the 9 pin connector for the joystick plugs into the chair when you plug in the charger cord the meter should move up and the lights on the joystick should flash indicating the charger is plugged in. When the chair is fully charged the meter should read zero or bounce up and down. Hope this helps

Jet 3 is typically 50 amp.

The controller is 40 amp.

What do you mean transformer?

Are you trying to charge? Do you have an onboard charger or separate unit?

I owned a medical equipment company for 10 years, so I know a bit about these, please provide more specifics as to what you are needing.

You can use the AC charger cord from a computer as a replacement for the AC cord of the charger. If the AC cord plugs into the wall and plugs into the charger or charger receptacle on the back of the power chair, you can use it.
If I remember correctly, This chair has a 4 Amp on-board charger which has an AC receptacle on the back of the chair to plug in an AC cord. The off-board chargers take a universal AC cord which will work with a universal computer AC cord. If the AC cord plugs in, use it.

Hi. The fault code you have is called the "Inhibit active".
It can be caused by a blown charger fuse, which causes the charger inhibit to activate.
Also if the 3-pin charger inhibit connector is not plugged in properly, or the connector is faulty, then the charger inhibit feature will activate.
Hope this helps. Neil.

You can email me at [email protected] and I can give you a quote for the charger.