Needto change seal between motor and generator

if the motor was overfilled it would blow a seal on oil look at the to main seals being bad should be under warranty

bad seal or loose flange bolts

Most likely at the output shaft of the motor. If you are handy, you might be able to replace the crankshaft seal yourself, but this will probably require you to seperate the generator from the motor, and remove the cover holding the seal. If the leak is small, it may be best to just keep adding oil. If you have to take it to be repaired, it may be more expensive than the unit is worth.

The crank shaft seal is bad on the motor. You will need to seperate the motor from the generator to replace the seal. Depending on the seal design, you will have to open the crankcase on the output shaft side to remove the seal.

Time to have the seal replaced

Hi,
I have 2kva generator, i want to change the oil seal, so how can i dismentle the generator, pl guide me step by step

When did it start happening while it was running? how old?

FixYa Support

Try eReplacementParts.com : Power Tool Parts and Tool Repair

you dont needto register you just download music to the itunes and ask it to upload it on ti your ipod

Whose engine do you have? Briggs and Honda have websites where you can down load their manuals and replace the rear seal.