No water to icemaker.

some models do have a water filter, which is either located at the bottom outside of the ref. on the kickplate,(grill), or inside the ref. itself on the ceiling. If both water to the ice maker and the drinking water stopped at the same time that is more than likely the problem.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/jason_4570d45317834dd3

I changed the water inlet valve on the fridge. It still doesnt send water to the ice maker, but continues to send water to the door, so what do i do now?

It's most likely the water valve in the rear of the appliance. This is located behind the rear panel to the right hand side. The valve supplies water to the ice maker on one side of the valve and water to the front panel for drinks on the other side. The water valve seems to be failing they are pretty easy to replace and not that costly if you can have a go yourself.

Hope this helps

frigidaire has put a diode in the harness @ the water valve sounds like diode is bad . hard to find @supply houses may have to order complete wire harness haundi24

when you look at this icemaker there are 2 sets of strippers 1 stationary the other moves. teh one that moves is normally at 2 o'clock position facing the front cover of icemaker. if these teeth are in anyother position for longer than 10-20 minutes then you most likely have a bad motor module on the icemaker, this is a very easy repair you will need partnumber 8201515 from whirlpool or local appliance supply house. thx peyton

If there are ice cubes setting in the icemake waiting to be dumped then the icemaker is bad. If the icemake is dry then the water valve is bad. You have one water valve with two solenoids. One works water in the door and the other sends water to the icemaker.

If there are ice cubes in the icemaker sitting there waiting to be dumped then the problem is in the icemaker. If the icemaker is dry then you have a water supply problem, even if you have a water in the door working.
1.Check the fill line inside the freezer at the icemaker, if it is clogged with ice then remove this ice and replace the water valve.

2. Check the water supply. Turn the water supply off, disconnect the water line from the Ref, turn the water back on an fill a small glass. If the water supply is good the solenoid on the water valve should be checked. This is done with an OHM meter.

If you got this far and need more info to DIY - ronbuice.com

mike you might have a frozen fill tube check for that also are you getting wtr ook at the dispencer if you dont recheck water supply again

GO TO WWW.SERVICEMATTERS.COM WHICH WILL GIVE YOU ASSESS TO ALL WP, AND MAYTAG JOB AIDS

If you need further help, reach me via phone at https://www.6ya.com/expert/marlon_56d9a24f02585258

how much water and did you have to shut off the water supply to stop it