How do I turn the screen on?

Get a better pc (without window 8)

motherboard problem. contact laptop technician

First Option:This Falut is Window.
Second Option:This Falut Is Hard.
Third Option:This Falut Is Board.

press fn button and with up-arrow increase brightness ,,, in windows open display settings by right clicking on the desktop (intel or nvidia properties ) acer 4320 could have nvidia or intel ... increase the brightness and the contrast or load the default settings ,,, use external monitor if need ...

This is a common problem with monitors when changing resolution. What probably happened is you may have tried to change the resolution, or an application changed the resolution, to an incompatible resolution.

For example, if you have a tiny little screen it can't display that huge resolution that a 32 inch monitor has. So, your monitor is stuck in that wrong resolution.

To fix this problem, you need to boot into Safe Mode. Restart your computer, and as it is booting up tap F8 a bunch of times, and then select Boot into Safe Mode.

When it boots up, right click on the desktop, click Properties (Windows XP) or Screen Resolution (Windows 7). When the window pops up, click Settings (if on Windows XP, if on Windows 7 skip to next step). From this window, change the resolution back to the basic 800 x 600 screen resolution.

Now, reboot your computer normally. You should be able to see the desktop. Now, you can do the same thing that you did in safe mode and turn up your resolution. BUT, when you change it, if the screen goes BLANK again, DO NOT press anything. After 15 seconds it should go back, and you can try a lower resolution.

Hope this helps! Thanks for using FixYa.

1st problem..... its a dell
2nd problem.....its winnders.

your software is corrupt or there is a hardware conflict.


Its like asking .........My car won't start...why not?

i

see power settings in control panel.
It must be set on blank screen after 20 mins or something like that.
set it like this
turn off hard disk- never
blanks screen - never

set never with everything


cheers

try ur windows disk,,put it in and go from there,,reformat if u have to,,or try sytem restore,,

MS-DOS edit command help edit myfile.txt <press enter>. This would bring up a blank edit screen, as long as the file is saved upon exit this will create the file myfile.txt.

MS-DOS edit command help edit myfile.txt <press enter>. This would bring up a blank edit screen, as long as the file is saved upon exit this will create the file myfile.txt.


Linux and UNIX xset command help The 'reset' flag forces deactivation of screen saver if it is active. The 'blank' flag sets the preference to blank the video (if the hardware can do so)

Read and follow instructions, good luck, please dont for get to Vote/Thank You