Need advisement on how to balance washer. It vibrates extremely when in the rinse/spin cycle and is very noisy. I have tried many things.

It sounds like there may be an issue with the balance of your washer. When a washer is out of balance, it can spin violently and cause the machine to reset. Here are a few things you can try:

1. Make sure the washer is level: Use a spirit level to check if the washer is level. If it is not, adjust the legs until it is.
2. Distribute the load evenly: Make sure the load inside the washer is distributed evenly. This will help to keep the washer balanced during the spin cycle.
3. Check for foreign objects: Make sure there are no foreign objects in the drum or the drum's seal, which may cause the washer to vibrate.
4. Check the suspension: Inspect the suspension system, which supports the drum and keeps it in balance. If the suspension is damaged or worn out, it will need to be replaced.

If the problem persists, it's best to contact the manufacturer or a professional technician for further assistance.

Some models of top-load washers use tub dampening straps to cushion the movement of the tub during the spin cycle. There are four straps attached to the top of the tub and to each corner of the cabinet

Also There are four suspension rods that suspend the tub and allow the tub to free float. If the suspension rods are noisy, there will be a squeaking noise during wash. You can fix this by putting bearing (lithium base) grease in the cup that each rod rests in. If it continues to squeal replace all four rods the cups come with the rods, replace them as well.

If your washer has a loud banging noise during spin the balance weight may be loose. This weight is to counter act the weight of the motor so you will find the weight directly behind the motor. Sometimes simply tightening the bolts will fix your issue but if the bolts are stripped out get some bolts slightly longer than the original bolt to allow you to put a locking nut on the bottom side of the mounting plate. If the weight is broken replace it.

Lastly Washer vibration can be caused by a broken counter balance spring. Ur washer may be equipped with one or more counter balance springs which help to absorb the natural movement of the spinning tub. If a counter balance spring fails the tub might lean in one direction more than another and it will shake and cause vibration.

sounds like the bearrings r gone

It sounds like your bearings are are whacked, if you have vertical
movement in the drum the bearings will need replacing , not a simple job as seals also need replacing

Hello !

It's possible to be the shock absorber worn out.

The 2 main causes for excessive vibration during rinse or spinout cycles are:

• Machine is out of balance....The adjustable feet can correct this or over time, it's possible the machine shifted slightly and is no longer level
• A worn belt whereby the tub wobbles more than it rotates; check for a worn belt.
  

when mine does that I just switch the spin speed to medium spin

I have the same problem. During the spin cycle, the washer spins all over the room.....very loudly.

Because front load washers are VERY HEAVY, they shake if you have a wooden floor. If your front loader sits on concrete and it still shakes, then you have to make sure all is balanced. If it still shakes, then inside the system there are shock absorbers that need to be checked.

Had the same problem but the motor pump was loose