What is the small light for - Computers & Internet

I think these are a 'Hook Out' light fitting. Look closely at the clear lense the light shines through. There should be a small slot in one end. Using a small screwdriver gently lever the whole light fitting out. This should give you access to the bulb holder in the back of the light fitting.
If There is no slot you might need to unbolt the plastic trim they are fitted into from the inside of the door panel. Small nuts about an 8 or 10mm.

1. Press the auto off and small cup at the same time. Then Immediately release and re-press the small cup three times.
When it works the only light showing will be the descale light.

2. Press the small cup button then auto off button then release small cup and then auto off, when this works the lights on will be the power button light and the descale light.

ALL OF THE ABOVE DURING THE PROCEDURE MUST BEEN DONE FAST OR RAPIDLY.

3. When both of the above lights are on,(power and descale), unplug for about 3 to 5 seconds... and plug back in. The brewer should come to life and work normally.

Below is the address and Phone number to Keurig warranty service.

Keurig, Incorporated
101 Edgewater Drive
Wakefield, MA 01880
1-866-901-BREW (2739)

if you put power to the small terminal and the solenoid still is not working chances are that it is bad, if it clicks it is likely good and the problem is with the neutral safety switchwith the small wire un hooked from the solenoid place a test light probe into the small wire and ground the other end of the test light to the battery if the test light lights the neutral switch is working

Clean all ports and reset the pump action as per the manual.

This range has a standing pilot light for the top burners and griddle top. If you look through the small hole under the flat top griddle you can see a small line about 1/4 inch that runs from the main gas manifold to the pilot light about 6 inches back under the griddle top. You will need a tightly wrapped piece of paper or a long match or small wooden stick, like a chop stick. Light the end of your paper, or stick and put it through the hole all the way to the pilot light. It should catch on fire. Whenever the main gas line is on, the gas will flow through the pilot light. If it will not light, there is a pilot light adjustment that is a very small screw in the middle of a 1/2 inch square metal fitting that is screwed into the gas manifold. If the pilot won't light, this screw may be turned all the way in, thus cutting the gas off to the pilot light. If necessary take a very small flat blade screw driver and turn the screw counterclockwise a half turn. That will increase the gas flow to the pilot light. Another way to light the pilot is to put your burning stick or match into the hole near the burner under the griddle plate, then slowly turn the heat valve to the on position. The main burner will light and then the pilot will light off of it. Don't get your face too close to the griddle when you light it, gas can flash back into your face.

the small lights on when you switch?Try to switch the small lights together with the main light at the same time..If the small light will off when you switch the main light is meaning that the batery is too weak.Thus you need to charge,but your one problem is that it doesnt charge?Check the wire if it has cut or loosen connector.Most of the problem about charger is the wire itself due to a regular shagling or moving during a charge will perform.If the wire is good,next to check is the fuse.,Finally,if all these mention parts are good,you must check the Rectifier Diode if it is shorted.If not,then you need to replace the batery because the problem is that it is not charging,but it is not storing a power on your batery.
On the other hand,,if at the same time you switch the lights and the small light is still on but the main light is still doesnt work: check if there is a fuse and see if it is open,or check the main bulb itself because maybe it was opened too?

the break light not working could be due to the pedal sensor not connected or faulty .check also the wiring loom under the seat as it could be disconnected .
in regards to the small headlights , check all fuses as you could have blown fuses as well .
contacts could also oxidise and not making contacts

you need a head light switch. buy from carquest (significantly less expensive then dealership).
remove knobs (small insert on pull knob press in with a small flathead while pulling towards you, twilight knob pops right off)

take off the cover plate over steering wheel (pop out with flat head screwdriver)

then cover over instruments (small torx bit 5 screws, 2 hidden by previously removed cover).

three small bolts hold in light switch.

http://www.compnine.com/largeimg/9410173C10-017.gif

may help in clarification

most likely a capless bulb or its comes with the seat/holder .

take somthing with a small tip, above the light there is a small hole stick it in lol. good luck!!!!!!!!!!!!