Adjusting the chronograph

What you need to do is to pull the crown to step 2 (full out) and then push the chrono top chrono button. Then the second hand will start moving one tick a time all through the dial. Keep pushing it until you reach to zero. then push crown back in,, That's it.

Pull the winder out to either the 1st or 2nd click. Use the push buttons to adjust the hands to the 0 posistion push winder back in.

mcdevito75 here, It could mean a weak battery, Best Bet, look for a small watch repair shop in your area, they will do the adjustments on your watch.

Well i am going to roll the dice and assume you have one of the ez clasps but if I am wrong you can send the model number and we will figure it out.

To adjust the ez clasp pull up on the front of the clasp loop while pushing down on the band. Rather than the traditional buckle and prong set up, the prong here is underneath the clasp loop.

Hope this helps. Thanks!

If the stop watch hands are not in the "0" (12 o clock) Position, follow the prodedure below to set them to the 12 o Clock position

1, Pull the crown to secound position
2, Press Button "A" for 2 seconds.
3, Press Button "B" to Adjust the minute Hand to "0" Position
4, Press Button "A" for 2 secounds then press Button "B" to adjust secound hand to "0" Position
5, Press crown into normal position

From:

AmFix Jewelry & Watch Repair
203 N. LaSalle Street,
Chicago, IL 60601
Ph: 312 641 7000
Email: [email protected]
Web: www.goamfix.com

I love these watches, don't you?

http://www.quorumtime.biz/pdf/Chrono_Alarm_Ronda.pdf

heres the pdf manual for this model...go to 'Adjusting the chronograph hands to zero position' and follow the instructions there..:)

Have a watchmaker fix it...there isn't anything you can do.

good after noon ! press the adjust button hold it up to 3 second when the digit is blinking thats time to set press the mode to select the digit that you want to change after that press the stert or reset button to change no digit ! thank you ! god bless !

Try setting the crown to position 2 - i.e. the position normally used to adjust the date.  Then use the top and bottom stopwatch buttons to adjust the minute hand and 1/10th hand respectively.