Cant get the numbers to work on right side of key board

Press the Start key + R.

type osk in that box and hit enter

On this keyboard, try toggling numlock scrolllock and capslock a few times.

Also, try this too: Fn+Numlk or depending of the model, press the button or Fn + Shift +Numlk hope this helps Try this. Press the Start key + R. type osk in that box and hit enter On this keyboard, try toggling numlock scrolllock and capslock a few times

Find a key called number lock on right hand side on top row. press once and see if numeric key board works! When you press this key there should a small indicator goes on or off! good luck!

By the "right side one"I am assuming you mean the number pad on the keyboard? Tap the Num Lock key once and see if that corrects the issue. Another unlikely but still possible solution is the region settings could be mis-set making your computer think it has a different keyboard layout.

You have Number Lock set on your PC - Have a look for a key top right hand side, it will have something like NumLck written on the KEY - you may need to use that Key in combination with the FN key - bottom left of keyboard - there should be a light somewhere on the keyboard which goes on/off as you toggle the NumLck key. You should see different coloured numbers on the key s*()UIOPJKLM These are the numbers and symbols that will be displayed when the NumLock is used

Programming is done on 7310, 7324 and 7316 type sets.
Enter programming by pressing the feature key followed by **266344.When prompted to enter the password enter 266344.
The screen should say TERMINALS&SETS. The 4 top line/feature keys are now used for programming.
At the terminals&sets prompt, press the show key (top right arrow).
The display should now ask for an extension number. Enter extension number you want to change the name on.
Press the show key (top right arrow)
The display should say LINE ACCESS
Press the next key (bottom right arrow) .
The display should say CAPABILITIES.
Press the next key (bottom right arrow) .
The display say Name.
press the Chng soft key. (or the clear key to erase)
use the dial pad to enter the name. advance using the arrow soft key to go to the next letter
ex. Bill = 2,2 -> 4,4,4 -> 5,5,5 -> 5,5,5
Press the next key (bottom right arrow) to enter the name.
Press the release key when finished

Go to
myhome.honeywell.com
and search for a manual for your model number thermostat on the right hand side of the page.
Hank

Unfortunatly you're not going to get anywhere without a proper key for Windows ME. Perhaps call Microsoft and they could verify your key for you and try a differnt one over the phone? If its the key that is stuck to the side of your PC or on the CD case it should work, if its different to the version on the CD or is for any other Microsoft product such as Microsoft Office, it wont work. Sorry for not being of more assistance.

Your bios probably is set to use the embedded keypad when the numlock is on. you can set it to numbers only when you press the FN key

I would start by restarting the computer.
If this does not solve the problem you are more then welcome to get back to me and I'll see if I can help you to further solve the problem.

Go to the front passenger side door and prise off the rear section - on close inspection you will see that it has a key symbol on it, the key hole is underneath.