Fills up with water no problem and then stops and will just make a click sound but doesn't do anything else but "click" from then on.
I posted on another question, I found that the problem was that the housing for the switch control was loose, as it did not snap shut. If you remove the lower panel and jiggle the wires, you may find that the problem goes away. This still points to loose connections in the control switch. I removed the switch wire assembly, having to cut the rubber "boot" near the door and taped the plastic housing shut. The problem appears to be that the drum, during the course of washing, would bump this plastic housing and cause the wires to become loose.
The motor have froxze up. First make sure the belt has not broke. Remove the rear cover and you will be able to access the motor and belt.
SOURCE: washing machine won't spin and drain
the drain pump is not working,after wash cycle the washer should drain the used water,if it does not function-all the next cycle will not commence.
337 views
Usually answered in minutes!
×