Why its not reconzing the M toner - Epson Aculaser C1100 Printer

use original toner OR reset toner indication

Try updateing the firmware on the device
http://www.archos.com/products/video/av_500/download.html?country=global&lang=en

If you are unable to perform a firmware update on the player you will most likely have to send it in for service.

You may need to download or update the drivers.
Drivers are what synchronizes the computer to the printer.

You can download them free from the printer's manufacture's website

Try another USB port, or turn off the computer before trying again.

you can only use a 2 or 4 bg

I might not be the right kind of RAM for that computer

well i know a lexmark, when i change the ink i always X in where it says a new cartridge . even if i refill my ink cartridge i never hit old just because i took it out. sometimes it will not recognize it if it old.than follow the step of a new cartridge installed. and print a test page and alinement just like you our setting it up for a new cartridge. sometimes if the computer doesnt reconze the printer i have uninstalled and reinstalled..hope this helps a little.

u will have to install the driver for the cam
u will get the drivers from the laptops srvicesite or any other site which provides the drivers....

their is nothing you can do as it has got wet it will have coroded the board sometimes if you are lucky it will dry out sounds like most of yours did dry out you can take the phone apart and buy some flux to clean the board with but this is hard to do as you need to be able to take the phone apart and make sure their is no static in your body cus this will deatroy the phone best thing to do is take it to phone shop tell them they will send it off to be cleaned for a fee but this should solve your problem some times they are beyond repair but you might be lucky it is the only thing you can do i dont advise taking the phone apart as you need special tools to do this and you need to make sure when you do it back up that you use a torque tool to tighten the screws up to the correct pressure but i advise you to take it to the shop to be done this should be cheaper then buying a new phone hope this is sopme help but their is not much you can do sorry