What are some midnight zone animals? - Computers & Internet

Animal ,vegetable or mineral.?
what is your subject, why not tell what is the subject.
what is this THING?
are you in the UK ,.we are not. we are USA>
Category Zone of Confidence ? wild guess #1
https://www.admiralty.co.uk/news/blogs/category-zones-of-confidence


if yes, why not ask them for sure we are not them.
nor is it a broken computer.

If anyone has an idea I would value the input. Thanks
You can try resetting your clock's settings every night and ensuring that you set the time one minute before midnight. This should prevent the buzzer from going off at midnight. If that doesn't work, try unplugging it for a few seconds and then plugging it back in to reset the clock. You could also try using a dedicated outlet for your clock, so nothing else is accidentally interfering with its timer setting. Finally, you could try replacing your current clock with a new one if none of these solutions work.

If it's showing alarm and the number 06, this means the panel believes zone 6 went into alarm. What's on zone 6, motion, door, panic button?

This is the end of me!

check the time zone on the clock .. and the region selected .. sync the clock to internet ..
if that does not help .. check cmos in case of laptop..
if neither help - call 1-877-805-1027 for expert help

IS your TimeZone is Correct?
Right click on your clock, choose Adjust Date/Time.
Click Time Zone Tab. Make sure your Time zone is correctly set.


Boot into the BIOS (setup) screens and check the date and time there. If the date is off by years then that verifies you need a new CMOS battery. Do not confuse the CMOS battery with the large external battery you run the computer with.

If zones are not advancing, then 1) Clock motor is not rotating dial > replace clock motor, 2) on-off trippers are worn down > replace trippers, 3) or the day skipper is set to skip all days and all skipper pins are pushed down, 4) or sprinkler valve is bad.

The sprinkler timer dial rotates each 24 hours. The trippers cause sprinkler head to turn on zone 1 for example. Zone 1 waters until the dial rotates to part of dial with no tripper. Without a tripper on the dial, the timer turns off circuit to sprinkler. At this point, the sprinkler valve mechanically advances to zone 2 and waits for timer to turn off again. The timer does not advance sprinkler to next zone > the sprinkler valve is designed to advance each time circuit turns off. The timer just turns on and off. When next tripper rotates around, the timer turn on the circuit and zone 2 begins to water.
http://waterheatertimer.org/pdf/How-to-Set-and-Troubleshoot-Intermatic-sprinkler-timer.pdf

The silver pin inserted at 12midnight position is for advancing the day skipper wheel.
Open following link for parts and resources:
http://waterheatertimer.org/Intermatic-trippers-and-parts.html#sprinkler

If You have'nt done so already. You have to go to time and date and click the Time Zone at the top
& if it shows Pacific Time America - Canada . Click the down arrow in time zone and
change that to Canbera,Melbourne, Sydney by scrolling down to see near the bottom of the page
Canbera -Melbourne -Sydney & click apply and OK

Hope this Helps

BillyG

Let me ask a question.
Is the time of day arrow pointing at the time of day right now?
If not, you can reset the time wheel by I think pulling it away from the body and rotating it.
If so, can you simply adjust the timer so that when it goes to the next day (10pm) it is really midnight and change any start times accordingly.
Do you need the 12 minutes between zones?
Gary