My whirlpool cabrio willot start has power when push start button it beeps back at me but will not start when door is open no ligh in dryer so iamsure itnot sensing door is closed I do nt see any wires how does it make contact and wha to look for

SOURCE: Whirlpool Gold Dryer

You will need a volt Volt-Ohm (VOM) reader to fix this problem.
This doesn't rquire sound technical knowledge for this but you should be good at following some instructions.
This could be the effect of a number of problems. Here's a list of things to check and details on how to do it.

• Fuse could be bad -- Check the fuse for a break inside. If it’s bad, replace it with an identical fuse.
• Temperature switch could be bad -- Use VOM to check the switch. Set VOM to RX1, remove leads and touch the probes to the switch's terminals. The reading should be zero or infinity. Turn the switch, and the reading should change from zero to infinity or infinity to zero. If not, the switch is bad.
• Thermostat could be bad -- Set the VOM to RX1, take a lead off one of the two outside terminals and press the probes to the two outside terminals. There should be a reading of zero. If not, it's bad.
• Heating coils may be bad -- Set the VOM to RX1 and remove the leads from the coil. Press the probes to the terminals. If the reading is zero, the coil is bad.
• Timer could be bad -- Disconnect the leads from the motor. Set the VOM to RX100. Clip the probes onto the leads. If the reading is infinity, the timer motor is bad.

SOURCE: whirlpool dryer will not spin

Since your dryer is "new" it is under warranty. I will explain the possible reasons why it will not spin. Then you can decide whether to make the warranty call or not.

If your dryer doesn't tumble, check these:

Belt
Motor
Door switch
Belt Dryers have a drive belt that turns the clothes drum. If the belt breaks, the drum stops rotating. Then you need to replace the belt, and often the idler pulley, because the pulley tends to wear out at the same time.

Click here for a belt installation diagram.

Motor If the dryer motor only hums when you press the Start button, the motor may be burned out. Here's how to test the dryer motor:

• Remove the belt.
  
  
• Check for obstructions in the blower fan housing.
  
  
• Manually rotate the shaft of the motor.
  
  

SOURCE: Whirlpool Cabrio dryer won't start - the "sensing" light is on

where are the answers on those stupid site

SOURCE: my whirlpool cabrio dryer start

http://www.partselect.com/dryer+dryer-wont-start+repair.htm

SOURCE: Whirlpool Cabrio Dryer Wont go past sensing light

my dryer sensing light was on and dryer would not start, we replaced the sensor fuse and now it works the fuse is in back of dryer close to the bottom on the left hand side very easy to replace cost $11.00 by the way don't call whirlpool they have no clue, wanted to send repair man out to fix it.