Where do I attach the cable from the new driver to the laptop on an HP M6-1045DX? Thanks

Hi, if you spilled liquid on the keyboard then it probably needs to be replaced,
Try this... you can remove the keyboard by removing certain screws from the bottom of the laptop, then you open the laptop like if you are using it look to for sliders around the keyboard edges or if it just snaps in place, use thin flat screw driver to carefully remove the keyboard but do not pull far.. it should still be attached with a wide flat cable to the main board... now lets try to remove the cable completely and re-attach it ( when removing the cable use your small flat screw driver to pull the plastic connector snaps from the sides of the connector to loosen the cable and be careful not to break the connector, when attaching back put the cable in first and hold it while you push the connector plastic back in place)... try the computer to see if the problem is gone, if not then order another keyboard and replace it. best of luck

Please install new driver and get it downloaded here : www.siliconguide.com > Drivers > Printer > HP
www.opendrivers.com/.../hp-free-driver-download.html
www.brothersoft.com/downloads/hp-printer-driver.html
Jay nmbhkl

Here are some great source where will will get any kinds of HP,ACER,DELL and COMPAQ laptop Solution and any kinds of Driver download.

» Hp Laptop's Solution
» Compaq Laptop's Solution
» Acer Laptop's Solution
» Dell Laptop's Solution
» Toshiba Laptop's Solution
» Asus Laptop's Solution

» Hp Driver's Download
» Compaq Driver's Download
» Acer Driver's Download
» Dell Driver's Download
» Toshiba Driver's Download
» Asus Driver's Download

jakauiay4

Dear sir,
install new oparating system and attach data cable in your pc then show a new hardware .
This printer is auto plug &play not driver requarments.If you are not success then change data cable with new one.
Thanks

Hi there,

Drivers for HP-Compaq laptops are available for download entering the laptop model on one of the following HP Support websites.


HP Support & Drivers

HP UK Support & Drivers

HP Software, Drivers Support

Alternatively post a new question on Fixya enclosing full model and operative system details.

Thanks

The HP Printer Scanner Copier 500 uses an advanced parallel cable design that meets the IEEE 1284C specification. This specification makes longer maximum cable lengths possible (up to 10 meters or 32.75 feet.).Unless you have an older laptop you most likely do not have a IEEE Parallel Cable. So what you are going to need to buy is a converter. You can get one here: http://www.jdoqocy.com/click-3380368-10440897?url=http%3A%2F%2Fwww.newegg.com%2FProduct%2FProduct.aspx%3FItem%3DN82E16812156005%26nm_mc%3DAFC-C8Junction%26cm_mmc%3DAFC-C8Junction-_-Cables-_-Sabrent-_-12156005&cjsku=N82E16812156005You can get the drivers here (just click on what operating system you have):http://h10025.www1.hp.com/ewfrf/wc/softwareCategory?lc=en&dlc=en&cc=us&product=58710&lang=en&You get get the Ink Here (just enter in the model information, they have your ink):http://www.computerwerks.org/Store/store.html

You need to disconnect the USB cable and set it up wireless on both units:
Since it is plugged into the router, it should already have an IP address.
Un-install the printer from the computers.
Then re-install the printer from the cd or from HP's website. When you get to the point where it ask you is the printer is attached to the computer or is it over the network. Choose over the net work and the software will find the printer IP and finish setting it up wireless.

If I could be of further assistance, let me know. If this helps or solves the issue, please rate it.
Thanks, Joe


I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309

You need to submit a new question specifying yourcomputer make and model.

If the PC is a no brand , or assembled, you need to look inside it and find the number printed on the motherboard.

To post a new question including model, click here : Solve
Your Problems

replace your cable,install the drivers than plug in the printer

you need to install your printer/camera driver..