How do I get rid of the rust on my appliances?

Hey Kenneth, I understand that you are receiving an "F11" error message on your Frigidaire Electric Range. Before considering contacting a service provider, I would recommend resetting the range by turning off the power to the appliance for about five minutes. After the five minutes return power to the appliance, this should allow the appliance to return to working condition. At this time if you find the problem still persists, you may want to consider contacting a professional technician. The concern could be the control board. Hope this helps! -JK

Try ebay, or thefind.com. Otherwise, some appliance recycle locations may have a used. Or a handy repair man may be able to fashion a repair or wooden replacement. If you still have the parts, and somewhat DIY inclined, JB Weld Epoxy and a metal threaded rod or similar reinforcement in a hollow handle may be the fix.

Hello,

Yes their is a paint for the microwave here are some links for it

WHITE http://www.repairclinic.com/PartDetail/Spray-Paint/261900/277

ALMOND http://www.repairclinic.com/PartDetail/Spray-Paint/350956/559

GREY http://www.repairclinic.com/PartDetail/Spray-Paint/350938/561

BLACK http://www.repairclinic.com/PartDetail/Spray-Paint/285006/470548

Note the manufactures part numbers then they coulkd be ordered their or at your local appliance parts store


GENE

Hi,

That is not that hard to fix and you can easily buy the parts yourself online...

Here is a tip that will help you with the online buying...

How to Buy Appliance Parts Online

heatman101

Hello,it would depend on the brand of appliance,its model number and how it was designed.In many cases the door may have to disassembled to access screws or nuts holding the handle ends.If the end caps which the screws or nut fasten to are stripped,the handle may need to be replaced.
Thanks

1) Isolate the unit by turning the power off at the main switch.
2) Remove appliance from housing unit.
a) When handling the appliance care should be taken to ensure the outer frame trim is not damaged.
b) The appliance is secured into the housing unit by 2 screws through the top corners of the front frame, open the doors and unscrew the 2 corner screws.
c) Grasp the bottom of the frame, pull forward and out onto a suitable surface.
3) Unscrew the top and rear panel securing screws and lift the panels clear.
4) From the rear of the appliance, pull off the 4 (top) grill element leads and the earth lead.
5) From inside the oven unscrew the 2 screws from the grill mounting plate.
The above is from the Handbook. I assume from point 5 the element is then free to be removed. reverse the procedure to fit the new element.
If you want a copy of the Handbook, then I will need an email address for you.

I have used appliance touch up paint to repair scratches and chips on ovens on enemel with out any problems.
I do not think you will have a problem
I do believe that there is a specific touch up for white enamel, but I don't know about other colours
Please leave feedback.
Thanks.

From one of our sponsers...
http://www.repairclinic.com/Appliance-Parts?s=t-jvm230wv-%3d%3dc226

Top oven works bottom oven fan works but bottom oven does not work and cannot get rid of auto signal