Remote turns of tv and it shuts down 3 seconds after

If model number posted is correct (let me know if something else) the set is shutting off either because of a problem in the power supply inside or something pulling that down.

Try unplugging the tv and taking batteries out of remote for a few seconds

01768,11034,11265, 10178, and 11748.
Or you can:
1. Press "TV" button
2. Hold "P" (program button) till the "TV" button flashes once then twice
3. Enter 9 9 1, and the "TV" should flash twice
4. Aim the remote at the TV and hold the Power button down for at least 3 seconds. (Remote automatically goes to first code but it probably wont work so go on to step 5)
5. Press CH+ repeatedly till the TV shuts off and stop immediately!
6. Hold "P" for 2 seconds
7. Hold "Select" for 2 seconds
8. Hold "P" for 2 seconds
9. Hold Power for 2 seconds and TV should turn back on
Found at:http://wiki.answers.com/Q/What_is_the_universal_remote_code_for_a_haier_tv
Be sure to rate macapplezoo 100% or whatever you think I deserve!

Hi.

Manual Programming:

1. Turn on the device with which you want to use the remote control.

2. Locate a 3-digit code for your device.

3. Press and hold the corresponding button on the remote control
(TV, VCR, SAT, DVD, CAB or AUD) for approximately three seconds unitl the POWER INDICATOR illuminates.

4. Enter the 3-digit code for your device within 30 seconds. The POWER INDICATOR shuts off.

5. Press power button to verify correct code entry. If the device shuts off, the code was entered correctly. If the device does not shut off, repeat steps 3-4, using a different code.





Automatic Programming

With automatic programming, the remote control tests all the codes available on the Code List and assigns the correct code for the selected device.

1. Turn off the device with which you want to use the remote control.

2. Press and hold the corresponding button on the remote control(TV, VCR, SAT, DVD, CAB or AUD) until the POWER INDICATOR illuminates. The remote control is in programming mode.

3.Press and release power button. The POWER INDICATOR flashes once and stays on
indicating the unit is in Power Scan mode.

3. Press CHANNEL UP or CHANNEL DOWN repeatedly until the device turns on.

4. When the device turns on, press OK to store the code.

5. Press any other button. If the device responds, the remote control has been programmed. If the device does not respond, repeat steps 2-5.

Codes for orion TV are
096,10,146
Thanx

a code will always read 12-normal if you just plugged the tv in. it has to try to turn on then shut itself down to log a code. Or shutdown is caused by something the tv cannot detect . Or a front panel button has failed- does the green light turn on for a second when you hit the power button on the remote? if not try unplugging the front keypad behind the speaker cover.

take the timmer of?

I have the same TV and just replaced the same lampTY-LA1000.
You have to reset the clock that times the lamp.Hold down the volume button(first you turn on the TV) while holding down the PiP button or the swap Button on the remote. that fixed mine.

It sounds like you might either have a bad power cord or you might have an over heating issue. Some times the TV will automatically shut off if it senses a fan issue or it starts to overheat. What technology is your set? DLP, LCOS, DILA...? If its under warranty I'd suggest to get someone out asap to take a look at it.

1.Check whether your Remote buttons jammed else on the TV.
2.there might be some problem Remote ir receiver unit in your TV
3. Microprocessor/microcontroller unit on Remote signal receiver board