, Hi good evening ,i need the lid tank for toilet tank 4440

Hi,

First, carefully remove your tank lid, and place it where it won't break or fall. Look for a four-digit number located on the back of the tank, near the water level mark. This is your tank model number. If the number starts with a two, it is a one-piece toilet.

Then....visit this link:
https://www.americanstandard-us.com/parts-support/faqs/toilets

Good Luck!

it is used to soften the lid to tank and keep it from rocking and china from rubbing

sounds like you need to adjust water level in tank,take lid off and check if theres enough water to flush should be a water level line in tank.

Your thought is probably correct. Usually toilet tank lids and feet on them to allow air enty. You might have to add rubber feet (self adhesive) or balance the lid on the tank differently.

Hi, Please don't take this the wrong way but did you install the hinges the right way? I fit bathroom suites for a living and have done this a few times wrong by putting the left hinge on the right side and vice verser. Sometimes the instructions are not very clear in explaining which side is left on the seat, as a result even though the toilet seat is closed, the springs are set backwards and are in fact in the up position. Double check the instructions once more, and just have a look on the hinges and seat because sometimes they have a small 'L' sticker on the hinge and an 'L' sticker on the seat and lid to correspond which hinge goes on which side. Hope this is of help to you.

Sorry to read about your problem, I hope this helps you out.

maybe somebody glued your tank lid shut... you just lift the tank top...no screws nothing..just lift it up

I tried to help you. Please help me and Rate/Vote on my response. We take the time to answer your question. take the time to rate us.Thanks and good luck

4 Thumbs - Very Helpful
3 Thumbs - Helpful
2 Thumbs - Somewhat Helpful
1 Thumb - Not Helpful

it sounds like it might be the floater ball in the toilet you can adjust the tension on it usually with a screwdriver.... if you look from the top down you should see a screw on the top of the arm that holds the floater adjust the tension and hopefully this will work

Try your local plumbers merchants [u need the make of the toilet] or thy local salvage yards www.salvo.com could be helpfull
Always take the broken lid with you

Hi bpmorr1,

It may be that the fill tube has come disconnected . It runs from the top of the fill valve to the overflow. The overflow is the tube that runs up the middle of the tank. The fill tube runs from the top of the fill valve to the top of the overflow tube. Kohler has a little clip that can sometimes come undone and cause spraying.


If that doesn't do it, turn the water off to the toilet and take off the tank lid. Partially open valve ( Slowly). Locate where spray is coming from. If it is in the area on top of the fill valve then yes, buy anew one. ( Fluidmaster )

Please rate this response and good luck, Phil