Whirlpool duet washer stuck at 1min in clean mode will not reset tried pause/cancel, unplug etc. nothing works when i hit pause cancel int appears on the screen

INT means interrupt I believe.
Just press 'play' again

it sounds like an electronic problem with the board.

I did as Drunan did and unplug for 10 and plugged it back in and it started like a champ! Thanks!!!!!! ;)

Hello there and thank you for chosing fixya
Here is a few things to check before you do a manual opening of the door
You may have already done these steps but please try this again in this order ok?

Check to see if the "Add a Garment" light is lit on the Duet's display. The light will only be on during the first eight minutes of a washer cycle, when the function is usable.
Press the "Pause/Cancel" button once to pause the washing cycle and unlock the door.Press the Press the "Pause/Cancel" button twice to cancel the wash cycle if the "Add a Garment" light is not illuminated. THIS IS A BIGGIE HERE (Wait for the water to drain. The door unlocks once enough water has drained to enable you to safely open the washer door NOW IF THESE STILL DO NOT WORK THEN HERE IS HOW TO MANUALLY OPEN THE DOOR
UNPLUG THE MACHINE
Remove the three screws securing the lower toe panel to the washing machine. The lower toe panel is the small rectangular panel underneath the washer's front door. Pull the panel off the washer once the three screws are removed.Reach up into the front panel of the washer. Feel for the teardrop-shaped tab in the washer's door latch assembly.Pull down on the tab until you hear a click. The click is the sound of the door unlocking.

Try unplugging the machine for 15 or 20 minutes and see if the computer resets itself. It worked for me.

Hi,
You should be able to just hit cancel. You might have to hold it for few seconds. I hope this helps if not let me know .

Unplug machine, wait 2 minutes and re-plug. This should reset computer and unlock door.

M duet was also haveing problems and when it would stop in a cycle it would flash a leter and a # F 02 I hit cancel and restarted it the time was all messed up I looked up the code for F 02 and found this page, I will post the link below. it was a drainage problem I cleaned out a trap in the pump really easy to do and it just might fix your problem. Regardless ever Duet owner needs to know this and matain this trap I pulled out a bowl full of stuck in it. Good luck!

http://www.fixya.com/support/r385845-checking_drain_pump_in_whirlpool_duet

Is the door firmly closed? Open the door and close it firmly. If the pause button is really stuck, you will need to repair/replace the board.

Unpluggin the machine is pretty much the only way to reset it.Leave it unplugged for a couple hours if that doesnt work its most like a control board issue