Bosch SD6P1B dishwasher: After closing the door the electricity can not be turned on with the main power switch. Electricity in the house and the plug is ok. Apparantly there is a fault with the door

Sounds like a shorted door switch. You may be confusing the door latch with the electrical door switch. The latch is the handle lever that you move to lock the door. The electrical switches you normally can't see without taking the door apart or in some cases they are mounted to the center top of the tub under the counter. As the door latches--the switches should close to run the dishwasher. It sounds like in your case it is defective and shorting to ground.

i had this awhile agow it was that the underneath drip tray was full of water touching electrics SO SWITCH OFF PLUG MAINS BEFORE YOU START ANYTHING had to empty tray and dry out with hairdryer no problems since then

E 20 bosch sd6p1b

be sure lock at door is not loose switch at door if not closed wont come on ck door close switch

If your dishwasher doesn't work at all, check these: Power from the house Door switch Wiring Timer or selector switch Power from the house Is there power getting to the dishwasher? This can be difficult to test, because dishwashers are usually wired directly to an electrical circuit, rather than plugged into the wall. But at least check for a blown fuse or a tripped circuit breaker. Door switch The door switch is important because, if it's defective, the dishwasher won't work at all. To reach it, you need to remove the control panel cover, or sometimes the interior liner of the door. If it's defective, you need to completely replace it. Wiring Often the main wiring connection from the house, at the dishwasher, burns and breaks the connection. If that's the problem, the wires must be repaired/replaced as necessary. If that's not the problem, check the wiring to the door switch, the wiring between the door and the lower part of the dishwasher, and the wiring to the timer. Repair any broken, burned, brittle, or defective wiring, using the proper appliance-grade wire and connectors. Timer or selector switch Although it's uncommon, the timer or the selector switch may be defective. If so, you need to re

I saw my repair man do the following, which you might try...
Open the door and simultaneously press & hold down the power button with the 2 buttons used on your model to "Cancel & Drain." If the unit comes on it now is in self-diagnosis mode. Release the buttons and close the door. The unit should start to fill with water. Press the power button to exit the mode.

From your description, I doubt that the problem is door latch is the cause.
The first thing that a modern dishwasher does before it begins to fill with water is run the drain pump.  It appears that this DW is not progressing to the next cycle (inlet water) and because the pump runs even when the door is open, I agree that the controller card may have failed.
If possible, inspect all the wire connections (remove main power before you do this) ... if there is a loose connection, the controller could do odd things.
Good Luck!  Please report back what you find, OK?

Hi, I think you will need to check the heater or the wash pump, as these are the first things to energised. IOf yo could give me some more information then i could tell you where to after these things have been tested ok!
Get back to me......

remove the door skin dont forget the two screws under the door in the middle,the control panel will lift off remove the power board(unclicks)remove the plastic case and see if its blown.But first also remove the lower kick plate at the front and check that you have power to the main terminal block.but most likley the main board,somtimes insects get into them.hope this helps.Ian ps did you push the main switch in top left i have had a lot of customers forget.

MAKE SURE THE DOOR LATCHING MECHANISM IS OKAY IT HAS A SAFETY POWER SWITCH CONNECTED TO IT

ALSO USE VOLTMETER TO MAKE SURE THE AC SOKET ITS CONNECTED TO IS GETTING POWER