Sound cuts in and out and sounds like a short in speaker

Check the speakers if they work. Connect the speaker terminals using a short wire to a 1.5 volt battery (AA or any dry cell batter) and listen if there's a thumping sound when the wires are connected to the battery terminals. If there's no sound, your speakers are busted. If there's a sound, check if the wires are okay. Use the same method with the battery with the wires from the back of your stereo. Make a small cut on the wire and attach the short wires you used earlier.

There is a short either on the speaker wires to the speakers or the speakers are defective (some sort of a short or too low of resistance). Lastly, check to see if a stray strand of wire is not touch the left and right terminals. Any short in the network (wire, lack of insulation, staple, screw, etc. ) will cause the system to clip.

try open each speaker test may be speaker or wire short....if all ok check pcb solder side....

Most amplifiers design to cut out when there is an overload, such as playing the music too loud. It helps protect the device from being damaged. If the device does it at low volume, and does it sometimes, check the wring to the speaker, something might be shorting it out intermitently.

you might have a short in your wiring somewhere. If your power wire touches any kind of metal it will ground it out causing it to cut off.

the speaker getting wet will short it out. Shorting the output on any amp will ruin it. there is a right and left chanel with 2 outputs. Right chanel is damaged.

it means there is some shorting in the speakers.. check for the shorting

have you ever tried to instal a sound blaster sound card on your machine

I have a db 1210 and i need the wireing plug for the speakers can you help

Sounds like poor wiring connections. Also, if one speaker shorts out, ALL speakers will shut off, so make sure there aren't any loose wires behind the radio or at the speakers. Sometimes wires get pinched in the door jamb and create a short as well.