Can anyone please advise on Lamona combi HSA7020 which will not work as a microwave despite all the display looking as if it will heat up but then it doesn't?

To cook with microwave only, press "Microwave/Grill/Combi", once, the screen will display "P100". Press "Microwave/Grill/Combi" to select the power level. Then press "Start/+30Sec./Confirm" to confirm and turn the dial to set cooking time. Then press "Start/+30Sec./Confirm" to start cooking on microwave only.

To switch to microwave/ grill combination cooking, choose C1 or C2 when selecting the power level.

See page 14 and 15 in the user manual.

Unplug the microwave for a few minutes, plug back in, set clock, open and close door. Make sure time displayed is correct,
Those are solutions to several problems, and I don.t know which one you have.

Lock-out Function for Children
Lock: In waiting state, press " Stop/Clear" for 3 seconds, there will be a long beep if the
time has been set, otherwise, the LED will display "Left brack equal equal sign right bracket "



Lock quitting: In locked state, press " Stop/Clear" for 3 seconds, there will be a long "beep" denoting that the lock is released.


If necessary, call the Lamona Service Line on 0845 00 60 00 and ask for assistance.

When you close the oven door, some micro switches are working. One of them is blocked. Check and replace the malfunctioning switch.

Microwaves have fault codes to help us determine the problem. Click the link below, it will take you to the Panasonic Combi Microwave site. Look at the manual closely. Either the fuses are blown or the microprocessor board is fried. Good Luck and be careful! Safety first! Commercial Microwave Ovens Large Microwave Commercial Kitchen Appliances...

The main fuse in the microwave oven has blown, usually caused by one or two defective door switches.

Is this a combi oven? If it is not-and only a micro then there is no heating element. Try it on micro(if its a combi) with a mug of water for approx 30 seconds to test it. If its a combi-is the micro function still working?

Generally, the most common causes of a failure to heat are:

- bad door switches or door switch mounts
- loose connection at the magnetron
- problem or loose conneciton on the control unit circuit board
- bad magnetron or other high voltage part

If you or a friend decide to look into it, we have critical safety information, info on door switch diagnosis and replacement, and
disassembly information at our site, linked here on Fixya: http://tinyurl.com/yzjozk