How to repair fixing unit of copier machine it replies Error C6000

It is fuser error try resetting it by running mode 163, otherwise replace the fuser unit.

I’m happy to help further over the phone at https://www.6ya.com/expert/mustafa_06f84c65ab5cc745

Hi,

The error code(C6000) Maybe the broken fixing heater wire. In fixing warm-up, the time to reach 50 degree(C)/122 F exceeds 10s, the time to reach the primary stabilization exceeds 10s or the time to reach secondary stabilization exceeds 24s. Or the Fixing heater M or s installed incorrectly. Check and re-install if necessary or replace the fixing heater M or S

Error C6000 related to fuser unit, you can try to reset to see if it works, other wise you need to replace fuser unit.
try to reset following these steps:
press on the panel the key 1078 1078, this will take you to maintenance mode.
now hite the key 163 And then hit the Start key.
select Execute and press Start key again.
Turn the machine off and on.

Good luck


I’m happy to help further over the phone at https://www.6ya.com/expert/mustafa_06f84c65ab5cc745

replace fuser

My kyocera taskalfa 180 shows an error.call service c6000.what should i do

Are you sure the error isn't C6000, which is a fixing unit error? If it is a C6000 then it maybe able to be reset in simulation mode if the fixing unit hasn't failed. Verify error code.

Hello sir; Just follow my instruction, I will help you to get rid off the error code; With front door open press10871087 then enter 163 press "start" key, final press " stop/clear " key to get out reset procedure.

Hi

Error C6000 is displayed when your machine fails to reach the correct temparature at a specific time.

This is a Fuser Unit Problem, try to reset it by--

First open top cover then turn on power.
press system menu/counter
arrow down to service
press and hold start, # then enter keys
arrow down to maintenance
press enter
arrow down to Sim 163
press enter
select execute
press enter
turn off power then back on

If the reset doesn't work then get your unit checked for fuser unit and fuser unit heat issues.

Please do rate this solution as FixYa and revert for further assistance.

Thanks
Rylee

In some cases you can reset the C 6000 - when is a false error.
try this:
1. Go to Menu/System and browse till you see
"Service".
press and hold: # START ENTER
The "Service" will go away and browse to "Maintenance".
2. Press ENTER to go in maintenace mode - the display change to Maintenance mode.
3. browse to 0163 and press ENTER - reset fuser
4. pick EXECUTE and press ENTER
5. turn the copier OFF, wait 20 seconds and power up the machine.
If C 6000 goes away it was a false error if NO ...try again and if the C6000 persist means the thermal fuse it is blown so you have to replace the fuse = call for service.

Have Kyocera FS-1118MFPF that is coming up with Error C6000. Can we fix this ourselves