I just had the tonner refill and then i notice.. i also clean the roller inside the drum then i notice one side of the printing pages really low.
The feeder assembly must be out of adjustment this is most likely at the drum. 85 bucks just in parts. Labor would depend on whom you choose to have it repaired with.
Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/edwy_1a56970cf1ea4620
SOURCE: how to put an IP address on the CopyStar CS-1820 printer
putting an ip to 1820, just go to system menu, scroll down look for the network setting, you will find ip address, then fill it up.
SOURCE: C710 Code on Copystar 2030
Did you disconnect telephone line?
C710 : Interrupted Communication at the Destination.
If you're the sender, it's happening outside your machine.
Most likely, phone line
SOURCE: Copystar cs-2550 drum replacement problems
ok. try this, take the rear cover off, theres quite a few screws. what i'm thinking has happened is you may have pushed the contact for the main corona wire out of place. this board is pretty flimsy. once you have back cover off, the board will be slightly to the right of center as u r looking at machine from rear. i can't recall EXACTLY what board looks like, but if you loosen your drum unit and have someone pull out drum a little and push back in, you will see what and where i am talking about. i'm a tech and had this bite me in the behind one time. will never forget it. hopefully, that will take care of it for you. let me know what you find.
good luck,
razors
SOURCE: Copystar CS-1815 waste toner
There are two screws on the drum unit. They are on the left hand side and one on the right hand side. Remove the screw from one side and take off plastic small side cover. Dump the waste toner. Do the same for the other side and then put it back together. Turn machine off then on and the error code should be gone......
86 views
Usually answered in minutes!
Hi ruben morales, I want to help you with your question, but I need more information from you. Can you please add details in the comment box? 1/ Was the copy good before you replaced toner cart? 2/ Did you remove the process unit?
×