Question about Craftsman 25cc Gas Line Trimmer

3 Answers

Craftsman 32cc Weedeater -- need fuel line diagram

All lines crumbled apart and I can't tell where the new ones should go. One line from the fuel tank (obviously), then there are two port on the primer bulb, and two on the carb. I need a fuel diagram. Thanks

Posted by on

Ad

3 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Craftsman Master
  • 1,545 Answers

The smaller diameter line (fuel supply) goes from the fuel tank (w/filter) to the carb body. Another larger line (purge line) goes from carb body to the right nipple on the primer bulb. Another large line (return line) goes from the left nipple of the primer bulb into the fuel tank. co0mpleting the purge circuit. This info pertains to my 2006 Craftsman 32cc with Zama carb.

Posted on Jun 01, 2010

  • zatoxman Nov 24, 2010

    the smaller lines goes to the upper input in the carb body or to the lower input? (carb body have to line input)

×

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 115 Answers

The smaller diameter tubing goes to the primer bulb into the tank, the larger from the tank to the carburator. The size of the nipple that the line fits on should also help in making this determination. Be sure to drain tank and reattach the filter that is probably laying in the tank. Thread that hose up through the filler hole to do this. I hope this helps.

Posted on Jul 06, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

When cleaning small engine carburators,o-rings and any plastic parts do not use any carb cleaner products.The cleaners when dry, attend to leave some residue in the cylinder wall of the carburator.I find that ammonia is a great cleaning solution,You can even clean any rubber or plastic parts without damaging them.It evaporates,there for it leaves no sign rsidue.Also,very inexpensive to buy at the dollar store.

Posted on Jun 15, 2011

  • rhump Jun 25, 2011

    I have the same problem. I have 1 large line from tankto primer bulb. I have 2 small connections on carb. which should go to the tank and which should go to primer?

×

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do the fuel lines in a weedeater trimmer pe550 hook up inside the gas tank


I have an older model that has a weighted filter in the tank. The filter flops around and can 'fall' into the fuel no matter which way you tilt the trimmer/tank. You should have one in your tank. Feed in the new line and make the end come out the gas cap. Push the filter/weight into the end of the fuel line. Pull the extra fuel line out of the tank to match the original position. You should have cut the new line to approximately the proper or same length as the old fuel line with an angle cut so you could push it into the tank.

Jul 23, 2014 | Poulan Craftsman/poulan/weedeater Fuel...

2 Answers

I have a Craftsman 32cc blower/vac model #358.797251. Replaced fuel lines and primer bulb. Getting fuel but won't start


Check for spark and air filter in good shape. Make sure bulb side gasket is OK! No leaks! Good luck!

Oct 16, 2012 | Garden

1 Answer

I need the fuel line routing diagram for a Craftsman Model No. 358.791510 Weedwacker 32cc/1.9 cu.in. 2-cycle


The fuel line in the tank connects to the nipple. It then goes into the small hole in the tank and then the fuel line from the carb connects to the nipple. This line is the line that is attached to the body of the carb, not near the plate.

Jan 18, 2012 | Homelite Consumer Products 4.0 Amp, 13 In....

1 Answer

I have a 32cc Craftman Brush wacker trimmer and the fuel line fell apart I need to know how to install the new ones.


This problem seems to be the biggest and most popular one by far in these forums and has been answered several times. Try and post your problem using the search feature on this site. Don't use too many words. Craftsman Weedeater Fuel Lines should be sufficient. If you can't get it, then post back here again please.

Aug 07, 2010 | Craftsman 25cc Gas Line Trimmer

1 Answer

Need to know the fuel line routing including the primer bulb.


The smaller diameter line (fuel supply) goes from the fuel tank (w/filter) to the carb body. Look carefully at the 2 nipples on the carb. You can tell one is slightly larger than the other. Another larger line (purge line) goes from carb body to the right nipple on the primer bulb. Another large line (return line) goes from the left nipple of the primer bulb into the fuel tank. completing the purge circuit. This info pertains to the Craftsman 32cc with Zama carb and may work on the 25cc model as well.

Jun 01, 2010 | Craftsman 25cc Gas Line Trimmer

1 Answer

Repairing fuel line on craftsman 32cc weed trimmer.


Cut the end of the line at a sharp angle. Spray WD-40 on the line and fuel tank hole. Slowly screw the line in the tank far enough so you can connect the fuel filter if you are replacing that line. If not just push the line into the tank if you have a two line system. Remember on the fuel primer, the long tip has the line going to the tank, and the short tip has the fuel line going to the carb.

Aug 24, 2009 | Craftsman 25cc Gas Line Trimmer

1 Answer

I have a 32cc crasftzman weed wacker need how to


This can be a little tricky, the filter is in the tank connected to the line. The line is pulled through a hole in the tank which seals only because the line is the correct outter diameter to seal the hole and not collapse the interior. Fuel line and filters are available at most places that carry outdoor power equipment parts but you must make sure the line is the exact size inner and outter as the original.
If the trimmer has a primer bulb the line goes from the tank to the bulb and then to the carburetor, a second line goes from the carburetor back to the tank, don't get them mixed up.

May 14, 2009 | Craftsman 25cc Gas Line Trimmer

1 Answer

Have craftsman 32cc gas line trimmer it runs until given gas


Replace the spark plug, clean the air filter and fill the tank with new fuel at the correct fuel oil ratio. Had the same problem last year. Tried to cheat with year old gas.

May 04, 2009 | Craftsman Garden

Not finding what you are looking for?
Craftsman 25cc Gas Line Trimmer Logo

19,987 people viewed this question

Ask a Question

Usually answered in minutes!

Top Craftsman Garden Experts

john h

Level 3 Expert

22486 Answers

Sheldon Dedek

Level 3 Expert

909 Answers

rjivaro

Level 2 Expert

158 Answers

Are you a Craftsman Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...