How do i reset fuser on ricoh spc312dn printer

SOURCE: Ricoh service mode to reset

This is the solution from Ricoh website:

Please press Menu. Then scroll to Maintenance and press Enter. Scroll to Color Regist and press Enter. Scroll to Color Regist Auto Adjust and then press Enter to Auto adjust. If after completing the procedure the error persists, please contact your service representative for support.

I'm told this works as well...
On the main board put dip switch 101-1 on and then off and then enter 97 and press the aps key. Then power cycle the printer.

Tim Babcock

• 2794 Answers
• Posted on Aug 07, 2008

SOURCE: Ricoh Fax 1140L

The only reset there is for it is to turn it off, wait 30 seconds, and turn it back on again. If it appears again, it needs service in case the thermistor needs to be replaced or something else.

SOURCE: Fuser Assembly Unit for RICOH Aficio MP 6500 Printer

This part number B2484582 is modified.
The new part number for the fusing unit is B2484583.
Yes, you can find it from a Ricoh Supplier.

Good luck and please rate me, thanks.

SOURCE: Ricoh fuser oil replace message

That is not a good idea. The oil is kept track of by counting pages, not by a sensor that measures the oil level. The oil runs out and the machine can't tell and now you have ruined the fuser. Which cost a lot more than the oil tank.

SOURCE: Error message - Reset Oil Fuser Unit Correctly

The fuser oil sits on top of the fuser and has silver contacts on it. Sometimes the contacts in the machine get bent. Turn off the printer and check the contacts and if bent use needle nose pliers to make straight again. Make sure the contacts on the fuser oil are not drity.