<!-- from fixya rte -->What does fault code e04 mean - Washing Machines

F04 E04 means low power voltage to dryer - check both sides of AC receptacle for 110 to 120VAC on each side to ground - check breaker panel for tripped or bad 220VAC breaker. Only one side may be suppling voltage to dryer.

F04 E04 means low power voltage to dryer - check both sides of AC receptacle for 110 to 120VAC on each side to ground - check breaker panel for tripped or bad 220VAC breaker. Only one side may be suppling voltage to dryer.
https://www.6ya.com/callphilipforhelp

The "E04" error code on your Bosch washer refers to a drainage problem as you may or may not already know. ( it can mean door lock error, but that is usually a by-product of it not draining )

What you may have is either a partially clogged pump, or a faulty pump...the later being the least likely

Hi
This error means that your outdoor unit can not communicate with one of the indoor units.
most probably one of indoor units has a trouble.

The E04 is a high pressure alarm which will shut down everything the compressor and blower except the condenser fan motor if is how it is program.

Hello, The "e04" error code means is an indication of a water temperature sensor error below 04'c
what it means is that there is over flow of water in the sensor reader around the wire and the sensor

what you have to do to fix up the problem is to unscrew (open)the washer then cleanup the water around and also the dirt sensor and wire and allow it to relax for some time after clean up

please the clean up DOES NOT NEED water or any form of liquid to do this just apply dry cloth for the cleaning.
Thanks

Hi,

E04 refers to Overheating. There might be plenty of reasons. You might have seen, if you shut down the ac for few minutes and again start it, It would work for few minutes and the same E04 display is there.

This is tech's job. I am sorry, i am not discouraging you but it requires certain testing that actually what makes ac overheated.

This is dangerous. So, better to call a tech and get it checked!!

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!

E 4-01 is a fuser error that only can be reset in service mode F9 reset fuser

Lisa, E04 is an error code which shows that one or both of the reels has stopped during play or record operation. We find that tapes with liquid contamination can stick to internal parts in the mechanism causing this error. Try another tape, if this does not resolve the problem something is defective in the tape transport. Good Luck to you! Joe Weibel customelectronics.org